Re: Emulex LP 9002

From: jeff barratt-mccartney (jbarratt_at_COMPSAT.COM)
Date: 02/25/04

  • Next message: Ayman Rayyan: "Re: Emulex LP 9002" 
    Date:         Wed, 25 Feb 2004 08:26:24 -0500
To: aix-l@Princeton.EDU

    yes. PCI-X is backwards compatible with PCI

    btw. I believe if you put the LP9002L card in a 32bit slot, it will
    negotiate at 1GB/sec also:
    remember that any PCI-X bus you put a card into will operate down to the
    lowest common denominator, so if you put a 33Mhz card in a PCI-X slot, all
    cards on that bus will run at 33Mhz

    -----Original Message-----
    From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU]On Behalf Of
    Ayman Rayyan
    Sent: Wednesday, February 25, 2004 7:18 AM
    To: aix-l@Princeton.EDU
    Subject: FW: Emulex LP 9002

    Dear all:

    I had found the compatible HBA card which is Emulex LP9002L & its
    supported by AIX 5.1, my notice is that this is a PCI 32 or 64 bit card
    while 650 & 630 are PCI-X, so does PCI-X slots supporting PCI cards ?

    -----Original Message-----
    From: Ayman Rayyan
    Sent: Wednesday, February 25, 2004 12:48 PM
    To: aix-l
    Subject: Emulex LP 9002

    Dear All:

    An any Pls. help to find the compatible emulex HBA to connect 650 & 630
    to symmetrix 8730 EMC storage ?

  • Next message: Ayman Rayyan: "Re: Emulex LP 9002"

    Relevant Pages

    • Re: PCI Slots
      ... PCI-X cards are supposed to be fully compatible with conventional PCI ... A long card in a short slot? ...
      (alt.comp.periphs.mainboard.asus)
    • Re: Adaptec Storage Manager reports "No controllers were found in this system"
      ... with the 2230SLP card and the SuSE OS though. ... but 66 MHz is not PCI-X mode. ... This is true only if the adapter card actually supports working at 100 MHz. ... It's listed as PCI-X 133 MHz or PCI 66 MHz. ...
      (comp.os.linux.hardware)
    • Re: SATA Raid (stress test..)
      ... PCI-X is backwards compatible with PCI and slower versions of ... for example you can put a standard PCI card in a PCI-X 533MHz ... 200MB/s - 350MB/s if your using a standard PCI slot. ...
      (freebsd-questions)
    • Re: looking for new server with pci 5volt slots
      ... but it's backward compatible with PCI, ... PCI-X and PCIe are 3.3V only, ... keep an ancient card around, it's time to plan a migration path. ...
      (comp.os.linux.networking)
    • Re: SATA Raid (stress test..)
      ... PCI-X is backwards compatible with PCI and slower versions of ... for example you can put a standard PCI card in a PCI-X 533MHz ... 200MB/s - 350MB/s if your using a standard PCI slot. ...
      (freebsd-questions)