Re: SAN Adapter Stats

From: Jason delaFuente (jason.delafuente_at_GBE.COM)
Date: 02/25/04

  • Next message: Bill Verzal: "Re: db2" 
    Date:         Wed, 25 Feb 2004 15:41:11 -0600
To: aix-l@Princeton.EDU

    If you are using the McData EFC Manager you can see all of the traffic at the switch port level by clicking on the switch/director, then going to the performance tab.

    Jason de la Fuente

    >>> D.Ousterhout@LABSAFETY.COM 02/25/04 03:19PM >>>
    Is there any way to get throughput statistics on my fcs0 and fcs1
    adapters? This is on a P690 with both adapters attached to McData
    switches and then on to our ESS800.

    Thanks
    -Darryl

  • Next message: Bill Verzal: "Re: db2"

    Relevant Pages

    • Re: Etherchannel or VIPa ? ?
      ... I have two ethernet adapters connected through two different Cisco ... It looks that Etherchannel requires a connection through 1 switch, ... survive a switch failure. ...
      (comp.unix.aix)
    • Re: round-robin mode for AIXs etherchannel.
      ... Trunking normally requires that all the ports are attached to the same switch ... What you may wish to do is create an Etherchannel with several adapters trunked ... Etherchannel) to an adapter on another switch. ...
      (AIX-L)
    • Re: 10/100/1000 Base-TX adapter in forced Gigabit mode
      ... > do not allow forcing in gigabit mode on the adapters, ... Does this also imply that the behaviour of an 'autonegotiate' switch ... and that therefore a solution like a "cross-link" cable (direct host ...
      (comp.unix.aix)
    • Re: 10/100/1000 Base-TX adapter in forced Gigabit mode
      ... >> do not allow forcing in gigabit mode on the adapters, ... >> You have to set the switch and the adapters to autonegotiate to get ...
      (comp.unix.aix)
    • Re: AIX 4.3.3 & FASTt 700 cannot see logical drive
      ... If you were not actually plugged in to the switch when the 6228 adapters ... [aix-l] AIX 4.3.3 & FASTt 700 cannot see logical drive ... If you have received this electronic transmission in error, please notify the sender immediately by a "reply to sender only" message and destroy all electronic and hard copies of the communication, including attachments. ...
      (AIX-L)