Re: LTO drive install problems
From: Patrick B. O'Brien (pobrien_at_DOIT.NV.GOV)
Date: 06/25/04
- Previous message: Patrick B. O'Brien: "Re: LTO drive install problems"
- Maybe in reply to: David Zarnoch: "LTO drive install problems"
- Next in thread: David Zarnoch: "Re: LTO drive install problems"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Fri, 25 Jun 2004 10:20:38 -0700 To: aix-l@Princeton.EDU
Where is the wrap plug? Use diag and wrap test it.
-----Original Message-----
From: Bob Booth - CITES [mailto:booth@UIUC.EDU]
Sent: Friday, June 25, 2004 9:40 AM
To: aix-l@Princeton.EDU
Subject: Re: LTO drive install problems
On Fri, Jun 25, 2004 at 11:34:22AM -0500, David Zarnoch wrote:
> Folks,
>
> I have been trying to install an LTO1 drive on a 6H1 and am running into a problem...
>
> I have the drive terminated and set to ID 0. The drive is connected to an Ultra scsi
> port.
> I have loaded Atape ver 8.4.8
> Basically, after I run cfgmgr, the drive is not recognized and the following error
> message is displayed:
>
> IDENTIFIER TIMESTAMP T C RESOURCE_NAME DESCRIPTION
> 825849BF 0625093804 T H fcs2 ADAPTER ERROR
> 3074FEB7 0625093804 T H fscsi2 ADAPTER ERROR
>
> I know the cable is good since I have used it quite often.....
>
> Is there something I am forgetting?
Check your terminator, make sure that you are using an LVD terminator and
not an HVD terminator.
Also, check for bent pins on all the cables and the terminator. Even one
will cause a grounding problem that will result in hardware errors.
bob
- Previous message: Patrick B. O'Brien: "Re: LTO drive install problems"
- Maybe in reply to: David Zarnoch: "LTO drive install problems"
- Next in thread: David Zarnoch: "Re: LTO drive install problems"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
