Re: Enclosure problem SSA

From: Green, Simon (Simon.Green_at_EU.ALTRIA.COM)
Date: 05/03/05

  • Next message: Holger.VanKoll_at_SWISSCOM.COM: "mixing scsi and san-disks in a vg" 
    Date:         Tue, 3 May 2005 12:52:59 +0200
To: aix-l@Princeton.EDU

    I believe we had a similar problem a year or so ago which was solved by
    replacing the controller card. However, if I remember correctly the
    engineer we had at that time said that the problem could also be caused by
    faulty connectors - the flex cable - or the operator panel.
     
    If the Service Guide is clearly directing you to replace the controller card
    then you can be fairly confident, but there are no guarantees. I take it
    you don't have any maintenance contract and are intending to do this work
    yourself?
      

    -- 
Simon Green
Altria ITSC Europe s.a.r.l.
AIX-L Archive at https://new-lists.princeton.edu/listserv/aix-l.html
New to AIX? http://publib-b.boulder.ibm.com/redbooks.nsf/portals/UNIX
 
N.B. Unsolicited email from vendors will not be appreciated.
Please post all follow-ups to the list.
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU] On Behalf Of
oscar torres carranza
Sent: 02 May 2005 23:22
To: aix-l@Princeton.EDU
Subject: Enclosure problem SSA
Hi,
 
I have the following problem. 
- the display of mi subsystem 7133 D40 donīt show nothing.
- I see in diag, SSA service aid and link verification show in the column
status for all the disks the word "POWER". The service guide
(GY33-0192-04)of the 7133-D40 say that if  there are the word "POWER" is a
problem of enclosure. I check all the  power supply and the blowers(fans)
and all they are on status O.K. This service guide too say that the problem
can to be the controller card on page 89 , step 15 so i have the SRN 301c0
and 2A106- Somebody had the same problem?. What i can to do?. I suspect that
the problem is the controller card. But i need to be very sure for to
solicite this part and donīt make a mistake.
  • Next message: Holger.VanKoll_at_SWISSCOM.COM: "mixing scsi and san-disks in a vg"

    Relevant Pages

    • Re: Rev 4 mobo disk trashing mystery
      ... power key, dark green slots, serial 27xxx something with 7930 date. ... I have tried different power supplies, different disk controllers, ... booting with the disk card in slot 6 causes ... try a different controller card. ...
      (comp.sys.apple2)
    • Re: RAID 5 Multiple Hard-drives failure
      ... HD for the RAID plugs in to the controller card ... Check the tolerance of the power supply. ... Then check the UPS, if the UPS only kicks in below the tolerance of the power ...
      (Fedora)
    • Re: what is 00003333 on P660 LCD?
      ... You need to refer to the Service guide for your particular model. ... For all diagnostic code, you should refer to the Service guide for the ... > We have power outage problem. ...
      (AIX-L)
    • 7013-590 power problem
      ... I think it's a fan problem, but have no real way to ... power to all the disk drives, ... copies of the 7013-5xx Installation and Service Guide? ... system guides. ...
      (comp.unix.aix)
    • Re: unattended start mode
      ... I have a B50 and I am trying to set it up for auto start after a power ... The service guide says I need to set a power on password ... Make sure that your boot image matches your running system: ...
      (comp.unix.aix)