Re: 5702 Dual Channel Adapter Card

I have a 550 with D20 I/O drawers and the 5702 dual channel adapter cards.
My internal 6-pack disk bay is connected to port 0 and I have a Sony AIT-2
tape drive (SCSI address 0) attached to external port 1. Take a look at
the internal cable ports on the adapter card. They should be labeled 0 and
1. Make sure they're cabled up correctly. Are you sure your internal disk
are on port 1? I'm not familiar with the 3580 LTO tape drive. Is it a
SCSI device?



I have a 550Q with a 5702 Dual Channel Adapter Card.
Port 1 is running the 6 pack bay of disks in the D20 I/O Drawer.
I am trying to connect Port 0 to a 3580 LTO Tape Drive.

Internally there are two SCSI connections from the 5702 card - one to each
of 2 6-pack bays of drives. I disconnected the one SCSI connection to the
second bay of drives (it is empty). Then connected the LTO tape drive to
port 0 on the 5702. When I boot up I get SCSI Bus errors.

I also tried to leave the internal SCSI connections the way they are (one
to each 6-pack drive bays) and I don't get the SCSI connection errors.. but
I also do not see my tape drive.

I have the correct scsi tape drivers installed.

I am sure I am not connecting this properly... any ideas?

(Note: I have a terminator on the LTO tape drive)


***************************defiant************************************
This email and any files transmitted with it are intended solely for
the use of the individual or agency to whom they are addressed. If
you have received this email in error please notify the Navy Exchange
Service Command e-mail administrator.

This footnote also confirms that this email message has been scanned
for the presence of computer viruses.

messaging_support_team@xxxxxxxxxxxxxxx
**********************************************************************

Relevant Pages

  • Re: Need help with bandwidth management . . .
    ... also be a good time to separate the wired from the wireless parts of ... wired connections. ... QoS lan port settings, and I cannot get anything consistent. ... switch ports and limit the bandwidth per port (the settings are ...
    (alt.internet.wireless)
  • Re: Iptables FTP question
    ... for secondary connections. ... Some ftp servers don't allow passive mode because it is less safe from ... algs that allow port mode for client machines. ...
    (comp.security.firewalls)
  • The newbie goes for a ride...
    ... rain on and off, it was never heavy enough to get out the rain gear...and we ... Friday morning we went on a bay fishing trip... ... Port O'Connor to Port Mansfield ... never ridden my bike on a ferry, and the rolling of the boat made me feel ...
    (rec.motorcycles.harley)
  • Re: Need Help on setting up a small home site.
    ... > told me that I have to open that port and forward request to my ... computer is the first network device. ... connections to port 80, so that they can be routed through to something ... > So if U don't consider it rude to post a long config file here, ...
    (comp.infosystems.www.servers.unix)
  • Re: Looking for program that emails me when dhcp addr changes
    ... For SSH all you need forwarded is TCP Port 22... ... >>participate in TCP connections or UDP conversations it initiates but ...
    (comp.security.ssh)