Re: HMC issues

pinhole is on display panel to the right of the white power button. insert a paperclip. the display will show 2 green bars, and then a graphic of a ball rolling will display, and the box will IPL




-----Original Message-----
From: IBM AIX Discussion List on behalf of David McWilliams
Sent: Thu 9/14/2006 10:18 AM
To: aix-l@xxxxxxxxxxxxx
Subject: Re: HMC issues

Where is the pinhole?

On 9/14/06, Jeff Barratt-McCartney <jbarratt@xxxxxxxxxxx> wrote:


have you attempted a pinhole reset of the managed server?



-----Original Message-----
From: IBM AIX Discussion List on behalf of David McWilliams
Sent: Thu 9/14/2006 8:58 AM
To: aix-l@xxxxxxxxxxxxx
Subject: HMC issues

I could use some help. I was installing an IBM P series server with a
Hardware Management Console configuration (HMC) with dhcp. By mistake, I
booted up the managed server before the HMC was configured and now the HMC
will not recognize the server to be managed. The managed server sticks on
a
hardware code of E000011 instead of the "01 N V=F" that means its
ready
for HMC discovery. The HMC management guide troubleshooting section
described flipping a jumper on the Service Processor Assembly board. I
performed the steps described and it still hangs on E000011. Does anyone
have any suggestions as to how to get this manages server connected?

--
Sláinte,

David

Checkout the, sometimes updated, McWilliams family website @
http://davidmcw.tripod.com

Get a safer, faster, better web browser @
http://www.mozilla.org/products/firefox/




--
Sláinte,

David

Checkout the, sometimes updated, McWilliams family website @
http://davidmcw.tripod.com

Get a safer, faster, better web browser @
http://www.mozilla.org/products/firefox/