Re: HMC issues

Can someone confirm the COM settings for the pSeries console port.

On 9/14/06, Vincent D'Antonio <dantoniov@xxxxxxxxx> wrote:

Dave,
Halt the system and go into the SP. select option #2 then option number
10 to reset the service processor. After that you can check to see if you
getting a DHCP address if you go to option #5 network options then option #1
to configure, then option #1 to configure eth0 you should see an address
from the HMC. I think the default address is 172.168.2.147, you might
need to then do the restore factory settings.

HTH,
Vince


On 9/14/06, David McWilliams <davidkmcw@xxxxxxxxx> wrote:
>
> I could use some help. I was installing an IBM P series server with a
> Hardware Management Console configuration (HMC) with dhcp. By mistake, I
> booted up the managed server before the HMC was configured and now the HMC
> will not recognize the server to be managed. The managed server sticks on a
> hardware code of E000011 instead of the "01 N V=F" that means its ready
> for HMC discovery. The HMC management guide troubleshooting section
> described flipping a jumper on the Service Processor Assembly board. I
> performed the steps described and it still hangs on E000011. Does anyone
> have any suggestions as to how to get this manages server connected?
>
> --
> Sláinte,
>
> David
>
> Checkout the, sometimes updated, McWilliams family website @
> http://davidmcw.tripod.com
>
> Get a safer, faster, better web browser @ http://www.mozilla.org/products/firefox/
>
>




--
Sláinte,

David

Checkout the, sometimes updated, McWilliams family website @
http://davidmcw.tripod.com

Get a safer, faster, better web browser @
http://www.mozilla.org/products/firefox/

Relevant Pages