Re: AIX 5.3 TL5 command for temp

Hi Larry,

2007/6/6, Larry Scheetz <LScheetz@xxxxxxxxxxx>:




AIX temperature sensors

By executing the command /usr/lpp/diagnostics/bin/uesensor,
you can, on supported platform, get the fan speeds and temperature of your
system:

[root@sys /] /usr/lpp/diagnostics/bin/uesensor -a


You are correct :), but the uesensor with -l option produce human
readable list.
for example on my 170 box:

Sensor = thermal sensor
Status = Normal
Value = 32 Degrees Celsius
Physical Location Code = P1

Sensor = fan-speed
Status = Normal
Value = 3840 RPM
Physical Location Code = P1-C1-F1

Sensor = fan-speed
Status = Normal
Value = 2850 RPM
Physical Location Code = F2

.....

Cheers,
Zoltan

Relevant Pages

  • Solved!!! Crysler voyager -95 3.3l Backfiring in aircleaner ,New info!!
    ... My Voyager is backfiring in the aircleaner at 3700-4000 rpm when i ... The CPS sensor was to close to the ...
    (rec.autos.makers.chrysler)
  • Re: Shoulda gotten a light cycle
    ... speedo and the rpm counter. ... It's got input from the gear ... shifters that tell it which gear it's in, and a speedo sensor, and then it ...
    (alt.sysadmin.recovery)
  • Re: 1991 Ford Explorer warm startup problems
    ... > it has trouble starting up again. ... It usually runs at about 1,000 rpm. ... Did you do a diagnostic test on it that said you needed the O2 sensor? ... If so, you may have more than one.....in mine, the check engine light came ...
    (rec.autos.tech)
  • Re: Thoughts on Troubleshooting Intermittant Faults
    ... (I've done Data Acq systems where it was ... Things like an optical sensor that determines RPM are a bear ... the detector, the alignment of the two, the alignment of the sensor ...
    (sci.space.policy)
  • Re: magnetism physics problem
    ... end the sensor connects to, the sensor will detect the tab. ... making a large target because of the scan time and response time issues. ... Dave is right that whatever is responding to the sensor must also have ... signature tooth rising edge at 2000 RPM -- and it has its own ...
    (rec.crafts.metalworking)