Re: PATCH - update TSC freq when cpufreq changes it

Poul-Henning Kamp wrote:
In message <45E4ADCD.4090909@xxxxxxxx>, Nate Lawson writes:

Attached is a patch that uses eventhandlers to update the TSC freq.

Question: are we at a point where the TSC-frequency reported by ACPI
is more precise than our own ad-hoc calibrations ?

It's a valid question, but mostly irrelevant. This code only comes into
play after the TSC freq has been changed by a cpufreq driver. If the
freq never changes, we always use the original boot-calibrated value.
For example, if the freq went from 1600 to 800 mhz, the original value
is off by 100% with the current code. The values supplied by the
cpufreq driver are definitely going to be a lot closer.

In the long term, I have some calibration code that bde@ helped with
that gets a very accurate value but may take a while to reach
equilibrium (since it runs with interrupts enabled). This would only
run once in a task thread the first time a given freq is chosen. Then
we'd cache that value for that setting.

--
Nate
_______________________________________________
freebsd-arch@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-arch
To unsubscribe, send any mail to "freebsd-arch-unsubscribe@xxxxxxxxxxx"