Re: issues between ATAng and pcm

From: Gordon Bergling (gbergling_at_0xfce3.net)
Date: 12/21/03

  • Next message: Stephan Uphoff: "Re: where is the rotating thing /^H-^H\^H|^H/^H-..."
    Date: Sun, 21 Dec 2003 21:27:14 +0100
    To: Mathew Kanner <mat@cnd.mcgill.ca>
    
    
    

    Hi Mathew,

    On Sun Dec 21, 2003 at 02:26PM -0500, Mathew Kanner wrote:
    > On Dec 21, Gordon Bergling wrote:
    > > I discovering a strange behavior which seems to be caused of issues
    > > between ATAng and pcm looking. I start burning a cdr with an atapi
    > > cdrw drive at low speed (4x) and the sound which is played by xmms is
    > > getting slower and slower. After a few seconds the system isn't responding
    > > anymore. One tone is played all the time and the system seems to be hard
    > > locked up. After nearly 60 seconds the system resumes normal operations.
    > > I had tried 3 times and the result is allways the same.
    > >
    > > My hardware is:
    > > ad0: 43979MB <IBM-DTLA-307045> [89355/16/63] at ata0-master UDMA100
    > > acd0: CDROM <CD-540E> at ata1-master PIO4
    > > acd1: CDRW <R/RW 8x4x32> at ata1-slave PIO4
    > > cd0 at ata1 bus 0 target 0 lun 0
    > > cd0: <TEAC CD-540E 1.0A> Removable CD-ROM SCSI-0 device
    > > cd0: 16.000MB/s transfers
    > > cd0: Attempt to query device size failed: NOT READY, Medium not present
    > > cd1 at ata1 bus 0 target 1 lun 0
    > > cd1: <IDE-CD R/RW 8x4x32 2,0> Removable CD-ROM SCSI-0 device
    > > cd1: 16.000MB/s transfers
    > > cd1: Attempt to query device size failed: NOT READY, Medium not present
    > > da0 at ahc0 bus 0 target 6 lun 0
    > > da0: <IBM DDRS-34560D DC1B> Fixed Direct Access SCSI-2 device
    > > da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing
    > > Enabled
    > > da0: 4357MB (8925000 512 byte sectors: 255H 63S/T 555C)
    >
    > echo "hw.ata.atapi_dma=1" >> /boot/loader.conf

    I try to burn a cd which hw.ata.atapi_dma=1 but the same error is coming
    up. burncd died with hundreds of "burncd: ioctl(CDRIOCSETBLOCKSIZE):
    Device not configured". The following messages were printed to the

    console: ata1: resetting devices ..
    acd0: WARNING - removed from configuration
    acd1: WARNING - removed from configuration
    done
    ata1-slave: timeout sending command=a0
    ata1-slave: error issuing ATA PACKET command
    psmintr: delay too long; resetting byte count
    (cd0:ata1:0:0:0): lost device
    (cd0:ata1:0:0:0): removing device entry
    GEOM: destroy disk cd0 dp=0xc2e33e00

    any hints?

    best regards,

            Gordon

    -- 
    Gordon Bergling <GBergling@0xfce3.net>	      http://www.0xFCE3.net/
    PGP Fingerprint:  7732 9BB1 5013 AE8B E42C  28E0 93B9 D32B C76F 02A0
    RIPE-HDL: MDTP-RIPE		"There is no place like 127.0.0.0/8"
    
    


    • application/pgp-signature attachment: stored

  • Next message: Stephan Uphoff: "Re: where is the rotating thing /^H-^H\^H|^H/^H-..."

    Relevant Pages

    • Re: Problem when adding a component in Target Designer
      ... > when I try to add the component to my configuration in the Target Designer, ... > Warning 1121: Can not find file resource paths for 'IntelGraphics ... The estimated configuration size may not be accurate. ...
      (microsoft.public.windowsxp.embedded)
    • Error encrypting identity element in web.config
      ... Using information that I got from this MSDN article: ... into problems when I try to encrypt the identity element. ... The command prompt says ""Encrypting configuration section...", ... Warning 1 The 'configProtectionProvider' attribute is not declared. ...
      (microsoft.public.dotnet.framework.aspnet.security)
    • Problem when adding a component in Target Designer
      ... graphics chipset component), using the component designer. ... when I try to add the component to my configuration in the Target Designer, ... Warning 1121: Can not find file resource paths for 'IntelGraphics ...
      (microsoft.public.windowsxp.embedded)
    • [SLE] Zabbix on Suse 10.1 ??
      ... I'd like to ask Suse users who're using the Zabbix monitoring system.... ... Warning. ... (in Configuration / General/ Housekeeper) ...
      (SuSE)