Re: 5.2R CD hangs during boot at sym0 device

From: Scott Long (scottl_at_freebsd.org)
Date: 12/31/03

  • Next message: Scott Long: "Re: Trying to install 5.2 RC2, failed ftp install" 
    Date: Wed, 31 Dec 2003 03:38:02 -0700
To: "C. Kukulies" <kuku@www.kukulies.org>

    C. Kukulies wrote:
    > I created a 5.2 boot CD from disc1.iso image.
    > When I boot that CD the system gets hung at the sym0 device:
    >
    > sym0: suspicious SCSI data while resetting the bus
    > sym0: dp0,d7/0, rst,req, ack i/o=0x3ffff, expecting 0x100
    >
    > After a couple of seconds that last message repeats about 10 times and
    > then nothing. Reset button required.
    >
    > The card is a PCI card with a NCR 53C810 chip on it.
    > No drives are attached to it and the SIP1,2 and 3 sockets were not
    > populated with terminating resistors, FWIW.
    >
    > I wanted to use that card as an interface to a Mustek scanner
    > since I have no ISA slot anymore in that MB (an ASUS P4P8X)
    > After taking out the card I could continue with installation.
    >
    >
    > --
    > Chris Christoph P. U. Kukulies kuku_at_physik.rwth-aachen.de

    Can you try disabling ACPI from the boot menu and seeing if that
    helps your problem?

    Scott

    _______________________________________________
    freebsd-current@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-current
    To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"

  • Next message: Scott Long: "Re: Trying to install 5.2 RC2, failed ftp install"