Re: Sil3114 SATA RAID

From: Søren Schmidt (sos_at_DeepCore.dk)
Date: 07/30/04

  • Next message: Roberto Nunnari: "hw.bus.devctl_disable: 0 -> 1"
    Date: Fri, 30 Jul 2004 15:00:11 +0200
    To: yuval levy <yuval_levy@yahoo.com>
    
    

    yuval levy wrote:
    > Good day
    > Is support for the Sil3114 (as found on Tyan S2882
    > motherboard) in RAID mode planned for FreeBSD 5.3?

    Depends on which RAID type your particular one is using. The "RAID" on
    these controllers are done in software so the driver has to know how to
    read the metadata defining the RAID setup from the drives.
    Currently I support Promise/HighPoint/LSI metadata, Adaptec is being
    worked on..

    -Søren
    _______________________________________________
    freebsd-current@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-current
    To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"


  • Next message: Roberto Nunnari: "hw.bus.devctl_disable: 0 -> 1"

    Relevant Pages

    • RE: FreeBSD 6.0 compat with DL320 G4
      ... even though FreeBSD 6.0 sees the disks if the ... RAID setup is switched on in BIOS, it does not see the RAID array so ... Until support for the Adaptec metadata format is added, ...
      (freebsd-questions)
    • Re: HP Embedded SATA RAID controller (FreeBSD 6.2)
      ... HP Embedded SATA RAID controller (FreeBSD 6.2) ...
      (freebsd-questions)
    • RE: FreeBSD 6.0 compat with DL320 G4
      ... what happens if you configure it via rc.conf is the server ... FreeBSD 6.0 compat with DL320 G4 ... If the ethernet chipset support at the moment is flakey then I might ... RAID firmware in this server is useless. ...
      (freebsd-questions)
    • Re: ra0
      ... FreeBSD is a registered trademark of The FreeBSD Foundation. ... configured irq 4 not in bitmap of probed irqs 0 ... I have two drives connected to a PCI ATA100 card. ... I am guessing this is some kind of Raid so used FreeBSD's auto config ...
      (freebsd-questions)
    • Re: File server hardware: HW or SW RAID?
      ... > We're building a new file server which will run FreeBSD and Samba, ... > have a question concerning the choice of RAID controller. ... Motherboard P4C800 Asus with ICH5 SATA chipset and Promise SATA Raid ... No kernel compilation is required and the SATA RAID promise controller works ...
      (comp.unix.bsd.freebsd.misc)