Re: nForce2 RAID MCP (SATA) support?
From: John Nielsen (lists_at_jnielsen.net)
Date: 12/23/04
- Previous message: Doug White: "Re: Some questions about Dynamic disks support in FreeBSD and about NTFS"
- In reply to: Brooks Davis: "Re: nForce2 RAID MCP (SATA) support?"
- Next in thread: John Nielsen: "Re: nForce2 RAID MCP (SATA) support?"
- Reply: John Nielsen: "Re: nForce2 RAID MCP (SATA) support?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: freebsd-current@freebsd.org Date: Thu, 23 Dec 2004 15:42:11 -0700
On Wednesday 22 December 2004 11:08 pm, Brooks Davis wrote:
> On Wed, Dec 22, 2004 at 08:48:31PM -0700, John Nielsen wrote:
> > What would be needed to simply have the controller recognized
> > and able to support UDMA 150 (or even 133)?
>
> At least in current, there's an nForce2 MCP device id that is supposed
> to support UDMA6 so I suspect you may just need to wait a bit and it
> will arrive. It's possiable you have a board with a non-standard
> PCI-id. You might make sure "pciconf -lv" shows that your controler
> shows a device ID of 0x008510de. If not, you may be a simple matter of
> adding it to the necessicary two lines.
Thanks, I'll try booting off a -current snapshot and see what shows up.
JN
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"
- Previous message: Doug White: "Re: Some questions about Dynamic disks support in FreeBSD and about NTFS"
- In reply to: Brooks Davis: "Re: nForce2 RAID MCP (SATA) support?"
- Next in thread: John Nielsen: "Re: nForce2 RAID MCP (SATA) support?"
- Reply: John Nielsen: "Re: nForce2 RAID MCP (SATA) support?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
