Re: DRI seems to bee broken

Peter Klett wrote:
On Tuesday 02 May 2006 21:12, Darren Pilgrim wrote:
you're begging for
an automatic podiatric firearm actuator device.

Ok, I made a cvsup, world and kernel, rebooted and tried again, same problem.

Did you go through the entire source upgrade process? The entire upgrade process being:

1: cvsup src
2: Read UPDATING and do any extra steps it may indicate.
3: Verify that your kernel config is still correct.
4: /usr/src/usr.sbin/mergemaster/mergemaster.sh -p
5: make buildworld
6: make buildkernel
7: make installkernel
8: reboot to single user mode
9: make installworld
10: mergemaster
11: reboot

Can I provide you with more infomation/configs ?

dmesg, pciconf -vl, kernel config, your complete xorg.conf and the Xorg log file from the last run.

_______________________________________________
freebsd-current@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • 6.1 kernel unable to find /dev ?
    ... the previously-good kernel would no longer ... | exec /sbin/oinit: error 20 ... | Automatic reboot in 15 seconds - press a key on the console to abort ... Should I perhaps to a make installkernel installworld ...
    (freebsd-stable)
  • RE: Upgrading 4.11-STABLE to 5.4-STABLE
    ... >> after my installkernel. ... If the kernel boots OK into single-user ... that successfully, then reboot the system and it fails, there is no way ... I just got familiar with portaudit a few weeks ago, ...
    (freebsd-questions)
  • RE: make world : did it fail?
    ... I know from the script output that the buildworld and buildkernel succeeded. ... The only step that is suspect is the installkernel. ... It reported the unpatched kernel. ... When I heard the computer reboot (it's sitting ...
    (freebsd-questions)
  • fxp0: device timeout
    ... I just ran cvsup and did make world. ... All seemed ok, after make installkernel ... reboot I did my usual ping test to make sure network was ok before running ... and no network response. ...
    (freebsd-current)
  • Re: Update to 5.2 beta from 5.1-current didnt work right
    ... At the tail end of the cvsup, src had already been completed, the system ... In this state I couldn't get the system to respond, and had to reboot it. ... but even with the new kernel the system won't boot into ... The installer had trouble, at one point reporting ...
    (freebsd-current)