Re: Fatal trap 12 during boot
- From: "Bruce M. Simpson" <bms@xxxxxxxxxxx>
- Date: Wed, 14 Feb 2007 14:55:05 +0000
Joel Dahl wrote:
Fresh kernel+world always panics with "Fatal trap 12: page fault while+1. I am getting this panic since cvs update about an hour ago and rebuild. This is not a GENERIC kernel. I have no SATA ATAPI devices, only the root disk for this system is attached via SATA-I.
in kernel mode" during boot, right after ata. Kernel from Feb 3 works
without any problems. Kernel is plain GENERIC.
Panic message: http://people.freebsd.org/~joel/panics/002/panic001.jpg
Backtrace part1: http://people.freebsd.org/~joel/panics/002/panic002.jpg
Backtrace part2: http://people.freebsd.org/~joel/panics/002/panic003.jpg
%%%
atapci0: <JMicron JMB363 SATA300 controller> port 0xdc00-0xdc07,0xd880-0xd883,0xd800-0xd807,0xd480-0xd483,0xd400-0xd40f mem 0xfe5fe000-0xfe5fffff irq 19 at device 0.0 on pci3
atapci0: AHCI Version 01.00 controller with 2 ports detected
ata2: <ATA channel 0> on atapci0
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0x8
fault code = supervisor read data, page not present
instruction pointer = 0x8:0xffffffff802c5151
stack pointer = 0x10:0xffffffff806fc5b0
frame pointer = 0x10:0xffffffff806fc640
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, long 1, def32 0, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 (swapper)
[thread pid 0 tid 0 ]
Stopped at rman_get_bustag+0x1: movq 0x8(%rdi),%rax
db> bt
Tracing pid 0 tid 0 td 0xffffffff805f8660
rman_get_bustag() at rman_get_bustag+0x1
ata_sata_connect() at ata_sata_connect+0x1bf
ata_ahci_reset() at ata_ahci_reset+0x114
ata_attach() at ata_attach+0x135
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
ata_pci_attach() at ata_pci_attach+0x18c
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
acpi_pci_attach() at acpi_pci_attach+0xf1
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
acpi_pcib_attach() at acpi_pcib_attach+0xf0
acpi_pcib_pci_attach() at acpi_pcib_pci_attach+0x97
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
acpi_pci_attach() at acpi_pci_attach+0xf1
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
acpi_pcib_attach() at acpi_pcib_attach+0xf0
acpi_pcib_acpi_attach() at acpi_pcib_acpi_attach+0xdb
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
acpi_attach() at acpi_attach+0x929
device_attach() at device_attach+0x292
bus_generic_attach() at bus_generic_attach+0x18
nexus_attach() at nexus_attach+0x19
device_attach() at device_attach+0x292
root_bus_configure() at root_bus_configure+0x1e
configure() at configure+0xa
mi_startup() at mi_startup+0xd3
btext() at btext+0x2c
%%%
Regards,
BMS
_______________________________________________
freebsd-current@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@xxxxxxxxxxx"
- Follow-Ups:
- Re: Fatal trap 12 during boot
- From: Bruce M. Simpson
- Re: Fatal trap 12 during boot
- References:
- Fatal trap 12 during boot
- From: Joel Dahl
- Fatal trap 12 during boot
- Prev by Date: Re: cpufreq est and Enhanced Sleep (Cx) States for Intel Core and above
- Next by Date: Re: Fatal trap 12 during boot
- Previous by thread: Re: Fatal trap 12 during boot
- Next by thread: Re: Fatal trap 12 during boot
- Index(es):
Relevant Pages
|