Re: hptrr driver panics on 7.0-RC2

Scott Long wrote:
Brian Biskeborn wrote:
Hello all,

I've reported this problem to HighPoint, but I'm curious to see whether anyone else has run into it. I'm using a RocketRaid 2314MS card on an amd64 system. When I boot the install CD for 7.0-RC2, the driver panics:

hptrr: (null): 180*32=5760 bytes
hptrr: (null): 180*288=51840 bytes

Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0x3
fault code = supervisor read data, page not present
instruction pointer = 0x8:0xffffffff80502032
stack pointer = 0x10:0xffffffff80fd0950
frame pointer = 0x10:0xffffffff80822ecf
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, long 1, def32 0, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 (swapper)
trap number = 12
panic: page fault
cpuid = 0

This is with no drives connected to the controller. My machine specs:
Dell Inspiron 531S
Processor: Athlon 64 X2 4000+
Motherboard: Asus M2N61-AX (seems to be made specifically for Dell) with the MCP61 chipset

So: has anyone else seen a panic with this or other HighPoint cards? I know HighPoint provides a binary blob for their driver, but could the problem be in the wrapper code someplace?

I wish I could provide more information, but not being able to install FreeBSD limits my options there. I had to take a picture of the screen and type in the panic output by hand :)


I'll take a look at it. Since you don't have any drives connected, can you remove the card and then do the install?


Heh, not a bad idea... Is there a way to hard-code the dump device into the kernel configuration? This crash happens too early for rc.conf to have any effect.

I tried building the kernel with online debugging enabled, but my USB keyboard doesn't work after the panic (and the box has no PS/2 ports).

Cheers,
Brian
_______________________________________________
freebsd-current@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • Re: hptrr driver panics on 7.0-RC2
    ... I've reported this problem to HighPoint, but I'm curious to see whether anyone else has run into it. ... I'm using a RocketRaid 2314MS card on an amd64 system. ... When I boot the install CD for 7.0-RC2, the driver panics: ... page fault while in kernel mode ...
    (freebsd-current)
  • Re: hptrr driver panics on 7.0-RC2
    ... page fault while in kernel mode ... has anyone else seen a panic with this or other HighPoint cards? ... you remove the card and then do the install? ... It panics with or without drives attached. ...
    (freebsd-current)
  • Re: hptrr driver panics on 7.0-RC2
    ... I've reported this problem to HighPoint, but I'm curious to see whether anyone else has run into it. ... I'm using a RocketRaid 2314MS card on an amd64 system. ... When I boot the install CD for 7.0-RC2, the driver panics: ... page fault while in kernel mode ...
    (freebsd-current)
  • hptrr driver panics on 7.0-RC2
    ... I've reported this problem to HighPoint, but I'm curious to see whether anyone else has run into it. ... I'm using a RocketRaid 2314MS card on an amd64 system. ... When I boot the install CD for 7.0-RC2, the driver panics: ... page fault while in kernel mode ...
    (freebsd-current)
  • Re: hptrr driver panics on 7.0-RC2
    ... When I boot the install CD for 7.0-RC2, the driver panics: ... page fault while in kernel mode ... has anyone else seen a panic with this or other HighPoint cards? ... Unfortunately I had to pull the card out and setup gmirror to get the ...
    (freebsd-current)