vpo in ECP
From: Paulo Roberto (nirv199_at_yahoo.com)
Date: 07/28/03
- Previous message: Bruce Cran: "BCM4401 driver"
- Next in thread: Terry Lambert: "Re: vpo in ECP"
- Reply: Terry Lambert: "Re: vpo in ECP"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 28 Jul 2003 11:01:43 -0700 (PDT) To: hackers@freebsd.org
Hello,
Sorry hackers, I have posted this to questions@freebsd, but got no
answer...
I did set my mainboard BIOS to use ECP transfer mode (dma 3 & irq 7). I
edited my kernel to:
device ppc0 at isa? flags 0x8 irq 7
(is there a way to declare the dma I want to use? config complains if I
add dma xyz)
and when I boot I get:
Jul 1 10:36:42 delta /kernel: ppc0: <Parallel port> at port
0x378-0x37f irq 7 flags 0x8 on isa0
Jul 1 10:36:42 delta /kernel: ppc0: Generic chipset (ECP-only) in ECP
mode
Jul 1 10:36:42 delta /kernel: ppc0: FIFO with 16/16/16 bytes threshold
Jul 1 10:36:42 delta /kernel: ppi0: <Parallel I/O> on ppbus0
Jul 1 10:36:42 delta /kernel: imm0: NIBBLE mode unavailable!
and my zip-100 drive does not get recognized. Is it possible to use vpo
in ECP mode?? EPP and compatible modes are just too damn slow.
thanks,
Paulo Roberto
__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscribe@freebsd.org"
- Previous message: Bruce Cran: "BCM4401 driver"
- Next in thread: Terry Lambert: "Re: vpo in ECP"
- Reply: Terry Lambert: "Re: vpo in ECP"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
