Re: Very slow writing to SATA disk

From: Matthew D. Fuller (fullermd_at_over-yonder.net)
Date: 10/28/05

  • Next message: Dinesh Nair: "Re: locking in a device driver"
    Date: Fri, 28 Oct 2005 02:02:37 -0500
    To: "Mikhail T." <mi@aldan.algebra.com>
    
    

    On Fri, Oct 28, 2005 at 01:18:03AM -0400 I heard the voice of
    Mikhail T., and lo! it spake thus:
    >
    > According to smartctl, the drive runs at 56C during the copying. Its
    > idle temperature seems to be 54C.

    That sounds a little high to me. Smartctl has been weird lately, and
    it only shows temp on one of my drives, but it (7200RPM 9gig SCSI) is
    showing 32C. The higher density probably burns a little more power,
    but half again the temperature?

    -- 
    Matthew Fuller     (MF4839)   |  fullermd@over-yonder.net
    Systems/Network Administrator |  http://www.over-yonder.net/~fullermd/
               On the Internet, nobody can hear you scream.
    _______________________________________________
    freebsd-hackers@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
    To unsubscribe, send any mail to "freebsd-hackers-unsubscribe@freebsd.org"
    

  • Next message: Dinesh Nair: "Re: locking in a device driver"

    Relevant Pages

    • Re: RAID drive failed, but SMART shows no errors?
      ... smartctl -t long /dev/sda ... run into this read error could be when sdb fails and you try ... If I can't hot-swap it, I'll need to replace it with the sdb drive, but right now grub is installed only on sda, so how do I install a copy of all the grub boot-related stuff on sdb? ... installation GRUB should be on both drives. ...
      (Fedora)
    • Re: Hard Drive Very Slow
      ... > boxes with varied motherboards etc. ... For smartctl, use man. ... As a personal note, googling around I discovered that more recent drives, ...
      (comp.os.linux.hardware)
    • Re: ad WRITE_DMA timing out frequently
      ... >> the behavior I'm experiencing is positively unrelated to the migration ... I've had 2 IDE drives die in this machine ... >I run smartctl on the systems, and none of the drives report any errors, ... My ATAPI controller is a VIA 82C686A as well. ...
      (freebsd-current)
    • Re: FYI: strange libata EH lines in dmesg once after every bootup
      ... commands. ... Either your drive does not support S.M.A.R.T., ... Smartctl: ... The funny thing is that I enabled smart on the drives themselves through ...
      (Linux-Kernel)
    • Re: Hard Drive Very Slow
      ... > I am trying to find some more specs on these drives now. ... >> Smartctl gives some strange numbers in some areas. ... # hdparm -tT /dev/hdc ... hda ...
      (comp.os.linux.hardware)