Re: Incrementing ierrs normal on switched network?

From: Dean Strik (dean_at_stack.nl)
Date: 01/23/04

  • Next message: Juan Jose Sanchez Mesa: "BGP4 using FreeBSD"
    Date: Fri, 23 Jan 2004 23:22:38 +0100
    To: Karl Pielorz <kpielorz@tdx.co.uk>
    
    

    Karl Pielorz wrote:
    > Hmmm, good point - as far as I'm aware everything connected to the switch
    > has both the 100Mbit & FDX lights on, but I'll check...

    Than it's probably ok.

    > Having been the victim of that kind of thing before - it usually really
    > screws up (i.e. lots of errors) - if it is that, this'll be the first time
    > it's actually left us with a 'usable' connection and not been in-sync w/the
    > switch...

    Have you tried replacing the cable?

    -- 
    Dean C. Strik             Eindhoven University of Technology
    dean@stack.nl  |  dean@ipnet6.org  |  http://www.ipnet6.org/
    "This isn't right. This isn't even wrong." -- Wolfgang Pauli
    _______________________________________________
    freebsd-isp@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-isp
    To unsubscribe, send any mail to "freebsd-isp-unsubscribe@freebsd.org"
    

  • Next message: Juan Jose Sanchez Mesa: "BGP4 using FreeBSD"

    Relevant Pages

    • Re: Blackout switch matrix problem
      ... The 40 pin connector between the ... I'm working on a switch matrix problem on a Williams Blackout. ... The system 3 through 7 driver boards are basically the same with minor ... some jumper wires replacing resistors in the switch inputs) so pretty much no ...
      (rec.games.pinball)
    • Re: Tech needed on TZ
      ... Too many times I see people just start "shotgun replacing" parts ... that all the optos are on that column 8. ... then do a test on the MPU board to see if the switch ...
      (rec.games.pinball)
    • Re: Problems with Startup
      ... When I switch the PC on it boots as far as the XP screen with the left to ... remove all none-essential accessory cards (everything but the video ... But if the problem does go away then try replacing the removed items ... back you will know that the last item you reconnected is the culprit. ...
      (microsoft.public.windowsxp.help_and_support)
    • Re: Hardware Problem?
      ... Just read your post about replacing the mobo--congratulations! ... |>switch was continuously depressed. ... Try unplugging the reset switch from ... |>pins which the power switch plugs into. ...
      (microsoft.public.windowsxp.basics)
    • Re: Tech help needed - 8-ball
      ... chip sockets for U7, U11, U10 with pin sockets, replaced the chips ... to be switch matrix problems and it turned out to be a connector issue. ... I buzzed all the connectors out on the mpu to verify good connections ... Also buzzed the u7, 10,11 pins after replacing ...
      (rec.games.pinball)