Re: DLT "device not configured" errors

From: Dan Nelson (dnelson_at_allantgroup.com)
Date: 07/29/04

  • Next message: up_at_3.am: "Re: DLT "device not configured" errors" 
    Date: Wed, 28 Jul 2004 20:15:50 -0500
To: up@3.am

    In the last episode (Jul 28), up@3.am said:
    > A few months ago I brought up a new server using an Adaptec 2200S RAID
    > card, and it's been running fine with a RAID 1 array on channel 0. Today
    > I tried to move the DLT (Quantum 4000) over to this server to make it the
    > amanda server, so I plugged it into the controller's external port for
    > channel 1. When I do, neither amanda or mt will see the device, I get:
    >
    > mt: /dev/nsa0: Device not configured

    This could mean that there's no tape in the drive. Does "camcontrol
    devlist" see the drive? Also make sure you have the "aacp" device in the
    kernel; that allows non-disk devices to pass through the raid controller and
    be seen by FreeBSD. 

    -- 
	Dan Nelson
	dnelson@allantgroup.com
_______________________________________________
freebsd-isp@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isp
To unsubscribe, send any mail to "freebsd-isp-unsubscribe@freebsd.org"
  • Next message: up_at_3.am: "Re: DLT "device not configured" errors"

    Relevant Pages
    • Quantcast