Re: DLT "device not configured" errors
up_at_3.am
Date: 07/29/04
- Previous message: up_at_3.am: "Re: DLT "device not configured" errors"
- In reply to: Dan Nelson: "Re: DLT "device not configured" errors"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Wed, 28 Jul 2004 22:12:55 -0400 (EDT) To: Dan Nelson <dnelson@allantgroup.com>
On Wed, 28 Jul 2004, Dan Nelson wrote:
> In the last episode (Jul 28), up@3.am said:
> > A few months ago I brought up a new server using an Adaptec 2200S RAID
> > card, and it's been running fine with a RAID 1 array on channel 0. Today
> > I tried to move the DLT (Quantum 4000) over to this server to make it the
> > amanda server, so I plugged it into the controller's external port for
> > channel 1. When I do, neither amanda or mt will see the device, I get:
> >
> > mt: /dev/nsa0: Device not configured
>
> This could mean that there's no tape in the drive. Does "camcontrol
> devlist" see the drive? Also make sure you have the "aacp" device in the
> kernel; that allows non-disk devices to pass through the raid controller and
> be seen by FreeBSD.
The "aacp" device did the trick, for both the drive and camcontrol.
Thanks!
James Smallacombe PlantageNet, Inc. CEO and Janitor
up@3.am http://3.am
=========================================================================
_______________________________________________
freebsd-isp@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isp
To unsubscribe, send any mail to "freebsd-isp-unsubscribe@freebsd.org"
- Previous message: up_at_3.am: "Re: DLT "device not configured" errors"
- In reply to: Dan Nelson: "Re: DLT "device not configured" errors"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
