AW: AW: only reload racoon.conf?

ok that's the problem: if i add a new remote peer (tunnel) to the file i
only want to load this new setting without stopping active tunnels.

thx

-----Ursprüngliche Nachricht-----
Von: David Richards [mailto:davidr@xxxxxxxxxxxxxxx]
Gesendet: Montag, 12. Dezember 2005 15:33
An: foobar
Cc: freebsd-isp@xxxxxxxxxxx
Betreff: Re: AW: only reload racoon.conf?

On 12 Dec 2005, at 14:07, foobar wrote:

> jeah, but i can't restart the program because it will close all vpn
> connections.
>
> i only want to load new setting from the "racoon.conf" without
> touching
> established connections.
>
> thx.
Wouldn't it be a good idea to restart the tunnels if you have made
any changes.?

--

David Richards
Eurosoft (UK) Ltd
3 St. Stephen's Road
Bournemouth
Dorset
BH2 6JL
England


Tel +44 (0)1202 297315
Fax +44 (0)1202 558280
Web: http://www.eurosoft-uk.com


_______________________________________________
freebsd-isp@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isp
To unsubscribe, send any mail to "freebsd-isp-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • Re: Linksys BEFVP41 with concurrent tunnels
    ... Two routers connect remote sites with dynamic IP addresses to a ... The connections are initiated by .... ... Though the tunnels have different subnets, ...
    (comp.dcom.vpn)
  • ssh port forwarding with suse 9.0 firewall enabled
    ... This as you can guess opens local ports 5110 which it tunnels to port ... If I turn on the default firewall config via Yast2 the connections take ... If I turn it off then the connections are instant. ...
    (alt.os.linux.suse)