Re: something wrong with fxp driver ?

From: Ying-Chieh Liao (ijliao_at_FreeBSD.org)
Date: 06/27/03

  • Next message: Gleb Smirnoff: "ng_ppp: how to send NGM_PPP_SET_CONFIG?" 
    Date: Fri, 27 Jun 2003 21:34:02 +0800
To: Robert Watson <rwatson@FreeBSD.org>

    On Fri, Jun 27, 2003 at 09:28:31 -0400, Robert Watson wrote:
    > You might compare the dmesg output from before/after and see if there are
    > any obvious changes in IRQ allocation, shared interrupts, etc. Perhaps
    > the changes in interrupt routing have resulted in some new behavior.

    I lost my old kernel :<
    (I make kernel twice... I thought it was scheduler problem, so I overwrite it
    by make another kernel ...)

    here's my dmesg (new, slow network kernel)

    Copyright (c) 1992-2003 The FreeBSD Project.
    Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
            The Regents of the University of California. All rights reserved.
    FreeBSD 5.1-CURRENT #2: Fri Jun 27 11:47:35 CST 2003
        root@Terry.CSIE.NCTU.edu.tw:/ad0/usr.obj/ad0/usr.src/sys/TERRY
    Preloaded elf kernel "/boot/kernel/kernel" at 0xc03c4000.
    Preloaded userconfig_script "/boot/kernel.conf" at 0xc03c41a4.
    Preloaded elf module "/boot/kernel/if_fxp.ko" at 0xc03c41f4.
    Preloaded elf module "/boot/kernel/miibus.ko" at 0xc03c42a0.
    Preloaded elf module "/boot/kernel/random.ko" at 0xc03c434c.
    Timecounter "i8254" frequency 1193182 Hz
    Timecounter "TSC" frequency 463910967 Hz
    CPU: Pentium III/Pentium III Xeon/Celeron (463.91-MHz 686-class CPU)
      Origin = "GenuineIntel" Id = 0x673 Stepping = 3
      Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
    real memory = 536870912 (512 MB)
    avail memory = 517308416 (493 MB)
    Pentium Pro MTRR support enabled
    npx0: <math processor> on motherboard
    npx0: INT 16 interface
    pcibios: BIOS version 2.10
    Using $PIR table, 6 entries at 0xc00fdef0
    pcib0: <Intel 82443BX (440 BX) host to PCI bridge> at pcibus 0 on motherboard
    pci0: <PCI bus> on pcib0
    pci_cfgintr: 0:9 INTA BIOS irq 12
    pci_cfgintr: 0:13 INTA BIOS irq 10
    pci_cfgintr: 0:15 INTA BIOS irq 11
    pcib1: <PCI-PCI bridge> at device 1.0 on pci0
    pci1: <PCI bus> on pcib1
    isab0: <PCI-ISA bridge> at device 7.0 on pci0
    isa0: <ISA bus> on isab0
    atapci0: <Intel PIIX4 UDMA33 controller> port 0xf000-0xf00f at device 7.1 on pci0
    ata0: at 0x1f0 irq 14 on atapci0
    ata1: at 0x170 irq 15 on atapci0
    pci0: <serial bus, USB> at device 7.2 (no driver attached)
    pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
    ahc0: <Adaptec 2940 Ultra SCSI adapter> port 0xe400-0xe4ff mem 0xea020000-0xea020fff irq 12 at device 9.0 on pci0
    aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs
    fxp0: <Intel 82557/8/9 EtherExpress Pro/100(B) Ethernet> port 0xe800-0xe83f mem 0xea000000-0xea01ffff,0xea021000-0xea021fff irq 10 at device 13.0 on pci0
    fxp0: Ethernet address 00:02:b3:99:3b:55
    miibus0: <MII bus> on fxp0
    inphy0: <i82555 10/100 media interface> on miibus0
    inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
    pci0: <display, VGA> at device 15.0 (no driver attached)
    orm0: <Option ROMs> at iomem 0xcd000-0xce7ff,0xc8000-0xcc7ff,0xc0000-0xc7fff on isa0
    fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
    fdc0: FIFO enabled, 8 bytes threshold
    fd0: <1440-KB 3.5" drive> on fdc0 drive 0
    atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
    atkbd0: <AT Keyboard> irq 1 on atkbdc0
    kbd0 at atkbd0
    vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
    sc0: <System console> at flags 0x100 on isa0
    sc0: VGA <16 virtual consoles, flags=0x300>
    sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
    sio0: type 16550A
    sio1 at port 0x2f8-0x2ff irq 3 on isa0
    sio1: type 16550A
    unknown: <PNP0303> can't assign resources (port)
    unknown: <PNP0a03> can't assign resources (port)
    unknown: <PNP0501> can't assign resources (port)
    unknown: <PNP0700> can't assign resources (port)
    unknown: <PNP0501> can't assign resources (port)
    Timecounters tick every 10.000 msec
    ata1-slave: timeout waiting for interrupt
    ata1-slave: ATAPI identify failed
    ad0: 6197MB <IBM-DHEA-36481> [12592/16/63] at ata0-master UDMA33
    acd0: CDROM <CD-524E> at ata1-master PIO3
    Waiting 2 seconds for SCSI devices to settle
    da0 at ahc0 bus 0 target 3 lun 0
    da0: <IBM DNES-309170W SA30> Fixed Direct Access SCSI-3 device
    da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled
    da0: 8748MB (17916240 512 byte sectors: 255H 63S/T 1115C)
    Mounting root from ufs:/dev/da0s1a 

    -- 
Pi seconds is a nanocentury.
					--- Tom Duff

  • Next message: Gleb Smirnoff: "ng_ppp: how to send NGM_PPP_SET_CONFIG?"

    Relevant Pages