Re: Setting up a NAT Router that will route between 3 networks
From: Jason Hunt (leth_at_primus.ca)
Date: 07/29/03
- Previous message: Julian Elischer: "Re: Differences between netgraph nodes in 4.x and 5.x"
- In reply to: hinkle_at_interwork.sdsu.edu: "Setting up a NAT Router that will route between 3 networks"
- Next in thread: Kenneth Culver: "Re: Setting up a NAT Router that will route between 3 networks"
- Reply: Kenneth Culver: "Re: Setting up a NAT Router that will route between 3 networks"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 28 Jul 2003 23:15:31 -0400 To: "hinkle@interwork.sdsu.edu" <hinkle@interwork.sdsu.edu>
On Mon, Jul 28, 2003 at 06:14:29PM -0400, hinkle@interwork.sdsu.edu wrote:
> I was wondering how to modify the appropriate files to setup a FreeBSD
> computer to act as a NAT Router, that would do the following:
>
Check the natd(8) man page, it should give you a good start. Chapter
19.12 in the handbook might be helpful as well.
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscribe@freebsd.org"
- Previous message: Julian Elischer: "Re: Differences between netgraph nodes in 4.x and 5.x"
- In reply to: hinkle_at_interwork.sdsu.edu: "Setting up a NAT Router that will route between 3 networks"
- Next in thread: Kenneth Culver: "Re: Setting up a NAT Router that will route between 3 networks"
- Reply: Kenneth Culver: "Re: Setting up a NAT Router that will route between 3 networks"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
