5.1-R plip0 issue (BSD --> Linux)
From: falacy (fbsdfalacy_at_shaw.ca)
Date: 11/22/03
- Previous message: Mike Tancsa: "Broken ppp LQR - FreeBSD or ERX ?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 22 Nov 2003 02:05:31 +0000 To: freebsd-net@freebsd.org
Hello all,
Seems that I am unable to do a few a things with the TCP/IP over parallel that
I would like to. I have setup my laptop using a linux-linux combo and it
pings just nicely, so I know that a plip connection will work on the hardware
once I figure it out. Here are my issues,
There isn't a plip0 device node in /dev, but
device ppc
device ppbus # Parallel port bus (required)
device lpt # Printer
device plip # TCP/IP over parallel
device ppi # Parallel port interface device
are called in my kernel config. This is rather disturbing.
This seems to be the real issue. I went through the handbook and used the 4.x
method to setup the parallel port connection, using the lp0 device node, but
that simply does not work in 5.1 apperently. I have not had any luck creating
a plip0 device node to use either, as the HB only states the 4.x method to
creating device nodes.
I also understand that use plip (called lp0) with linux under freeBSD 4.x,
freeBSD needed to have 'ifconfig_lp0 link0' called, but I am not sure if this
is the case for the plip0 too (in freeBSD 5.1). Nor, in either case, am I
sure where I would call link0....
My setup in /etc/rc.conf looks like this (and would work in 4.x from what I
have read),
interfaces="lo0 xl0 lp0"
ifconfig_xl0="inet 127.0.0.1 netmask 0xffff0000"
ifconfig_lp0="inet 192.168.1.5 192.168.1.9 netmask 0xffffff00"
Can we find a way to make this system work with 5.1? Quite frankly, I'm at my
wits end when it comes to this. I like FreeBSD, but if I can't figure this
out, it would be well worth my while to just go back to slackware, I guess. I
don't really want to do that however :)
Thanks in advance,
Rob.
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscribe@freebsd.org"
- Previous message: Mike Tancsa: "Broken ppp LQR - FreeBSD or ERX ?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|