Re: NDIS: How can I help with these (2nd request).

From: Mike Silbersack (silby_at_silby.com)
Date: 05/29/04

  • Next message: Larry Rosenman: "Re: NDIS: How can I help with these (2nd request)."
    Date: Fri, 28 May 2004 22:51:19 -0500 (CDT)
    To: Larry Rosenman <ler@lerctr.org>
    
    

    On Fri, 28 May 2004, Larry Rosenman wrote:

    > I E-mailed you (Silby) the driver. You should also be able to use
    > ports/archivers/cabextract to pull stuff from the cab's.
    >
    > LER

    Neat, I didn't know we had that util in ports. I tried it on the cabs,
    and it told me to use "unshield", which was also in ports, so I was able
    to pull them apart in the end.

    After looking through the cabs from linksys's installer, I agree - there
    is only one non-9x series driver. Looks like the only way to get the card
    working properly may be to send Bill one of these cards and hope that he
    has time to debug the problem.

    In the meantime, you're probably best off buying another card, perhaps one
    of the ones supported natively by ath(4) or one known to work with the
    NDISulator properly.

    If you can find any linux NDISulator support boards it might be worthwhile
    poking around there... if the driver is also broken there, maybe there's
    hope that a new driver will fix the problem.

    That's the end of my knowledge of the NDISulator, good luck! :)

    Mike "Silby" Silbersack
    _______________________________________________
    freebsd-net@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-net
    To unsubscribe, send any mail to "freebsd-net-unsubscribe@freebsd.org"


  • Next message: Larry Rosenman: "Re: NDIS: How can I help with these (2nd request)."

    Relevant Pages

    • Re: NDIS: How can I help with these (2nd request).
      ... I tried it on the cabs, ... I'm always amazed at what we have in Ports. ... Looks like the only way to get the card ... > If you can find any linux NDISulator support boards it might be worthwhile ...
      (freebsd-net)
    • Re: [RFC/CFT] Split 8250 port table (part 2)
      ... The only ports which remain in asm-*/serial.h are the platform specific ... * The following define the access methods for the HUB6 card. ... the interrupt is at irq3 ...
      (Linux-Kernel)
    • Re: 1-wire to USB converter that can use 1820s directly
      ... than to need to add another PCI card to support serial ports. ... how someone could finally say "not one more f'ing wire!" ...
      (comp.home.automation)
    • Re: ARCHIEVE, RESTORE and flag handling
      ... it does not clear ports 1-3. ... Is the entire backup segregated into a directory ... The idea is to take a formatted SD card and make a copy ... from where it could be executed, ending with RESTORE; ...
      (comp.sys.hp48)
    • Re: ng_fec and cisco 2931
      ... >4 ports) has determined that it appears to have a 100 megabit limit to ... >card in total. ... I have a 3com (xl0) and a davicom 9102 ... ngctl msg dc0: setpromisc 1 ...
      (freebsd-performance)