Re: Gateway/Router

From: Anton Bester (extech_at_dod.co.za)
Date: 11/19/04

  • Next message: Olivier Nicole: "Re: Gateway/Router" 
    Date: Fri, 19 Nov 2004 09:29:32 +0200
To: "Olivier Nicole" <on@cs.ait.ac.th>

    >Looks OK, what is the IP address of your interface ed0?

    rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
            inet 192.168.1.1 netmask 0xffffff00 broadcast 192.168.1.255
            inet6 fe80::210:b5ff:febe:74c6%rl0 prefixlen 64 scopeid 0x1
            ether 00:10:b5:be:74:c6
            media: Ethernet autoselect (100baseTX <full-duplex>)
            status: active
    ed0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
            inet 196.25.53.66 netmask 0xfffffff8 broadcast 196.25.53.71
            inet6 fe80::2c0:dfff:fea3:54d%ed0 prefixlen 64 scopeid 0x2
            ether 00:c0:df:a3:05:4d
    lp0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> mtu 1500
    lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
            inet6 ::1 prefixlen 128
            inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
            inet 127.0.0.1 netmask 0xff000000

    _______________________________________________
    freebsd-net@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-net
    To unsubscribe, send any mail to "freebsd-net-unsubscribe@freebsd.org"

  • Next message: Olivier Nicole: "Re: Gateway/Router"

    Relevant Pages

    • RE: How do I manually set the MTU on a PPP Connection?
      ... Subject: Re: How do I manually set the MTU on a PPP Connection? ... > ...when I dial-up using pppd or wvdial... ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ... Trouble? ...
      (Debian-User)
    • Definition of interfaces in ifconfig
      ... lp0: flags=8810mtu 1500 ... I assume lp0 is the parallel port, don't need it, don't plan to do any ... I assume lo0 is the loopback interface, ...
      (freebsd-newbies)
    • Re: iptables to ipfw
      ... It turns out that openvpn configures tun0 with too small a MTU which causes ... According to RFC 1918, unregistered source ... > as an extra flag to natd ... >> To unsubscribe, send any mail to ...
      (freebsd-questions)
    • Re: Fw: MTU Path Discovery Problem
      ... and refused to listen to messages generated by ifconfig when changing the mtu ... Then when the response to mtu discovery probing began, ... > The BSD computers are setup as gateway routers. ... > unsubscribe, ...
      (freebsd-hackers)
    • Re: cable modem connection slower than dial up
      ... up ifconfig mtu 1450 ... after doing a ifdown -a and ifup -a I could verify the mtu by ifconfig ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ... Trouble? ...
      (Debian-User)