trunk on re0 interface

Hi,

I got a FreeBSD (6.1) connected to a Cisco switch 2950 (12.1).
The speed on the re0 interface is 100 Mbps full duplex but when it get
connected to the Cisco it turns out 10baseT half-duplex ?

I can create VLAN attached to this interface, and this seems to work
but is there anyway to speed up the tagging process ? (ifconfig tells
this interface does hardware tagging)

Any hint about this ?

Thanks a lot,

Sylvie

_______________________________________________
freebsd-net@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • Re: ndd interface issues
    ... Grab the S95net-tune script off the net and put it into the /etc/rc2.d ... Edit it so it matched your interface ex: ... Execute the script as root it should update on the fly. ... They are both connected to the same cisco switch, ...
    (comp.unix.solaris)
  • Re: Problem Daisy-Chaining 2950 Using Copper Giga
    ... > Did you check the speed and duplex settings of the running ports. ... >> switch to connect to two other 2950's using switchport mode trunk for VLAN ... >> interface FastEthernet0/1 ...
    (comp.dcom.sys.cisco)
  • Re: Problem Daisy-Chaining 2950 Using Copper Giga
    ... My first thing to check would be to see whether one port came up in duplex and the other in half duplex or so. ... switch to connect to two other 2950's using switchport mode trunk for VLAN ... extremely high number of input errors on the VLAN1 interface of the ... no spanning-tree optimize bpdu transmission ...
    (comp.dcom.sys.cisco)
  • Re: two NICs and speed issues
    ... > So if you disconnect the modem the transfers are fast on the ... > will give you a listing of each interface. ... > connections you want to have full duplex set. ... > between the NIC and the switch you will see the error count increase ...
    (Fedora)
  • Re: Dropped packets via ISR
    ... I also used ping plotter... ... Tried changing from full duplex to half duplex to auto and that did ... "1) Interface MTU at 1500 is fine. ...
    (comp.dcom.sys.cisco)