vge(4) slow at 10baseT



I have just had occasion to use a vge(4) as an interface to as DSL
modem.

When using the same DSL link with an fxp(4), a dc(4) or an axe(4)
interface, various DSL speed tests on the net show the line at its
correct speed of 1536/384 (up/down).

But on the vge(4) interface downloads are noticably slower, and in
fact, the line tests only as 768/128, i.e., about half speed.

The DSL modem runs at 10baseT half-duplex.

Anyone have thoughts as to why this may be?

-jr



vge0: <VIA Networking Gigabit Ethernet> port 0xf800-0xf8ff mem 0xfdffe000-0xfdffe0ff irq 18 at device 14.0 on pci0
miibus0: <MII bus> on vge0
ciphy0: <Cicada CS8201 10/100/1000TX PHY> on miibus0
ciphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
vge0: Ethernet address: 00:40:63:eb:5a:f9

vge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
options=1b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING>
inet6 fe80::240:63ff:feeb:5af9%vge0 prefixlen 64 scopeid 0x1
inet 66.171.79.77 netmask 0xffffffc0 broadcast 66.171.79.127
ether 00:40:63:eb:5a:f9
media: Ethernet autoselect (10baseT/UTP)
status: active
_______________________________________________
freebsd-net@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscribe@xxxxxxxxxxx"



Relevant Pages

  • Re: Firewall und Linux
    ... such eich mal *g*) und das verkappte DSL ... Hat das Interface eine statische IP, ... bekommt vom "DSL Modem" zugewiesen. ... PGP Key available on public key servers ...
    (de.comp.os.unix.linux.misc)
  • Re: show interfaces output - explain?
    ... If you want to check your xDSL speed use show dsl command and look for Speed ... Total bandwidth for that interface? ... reliability 255/255, txload 11/255, rxload 6/255 ...
    (comp.dcom.sys.cisco)
  • Re: pf multiple networks, two gateways, route-to question
    ... "Adam Taube" wrote: ... %Now what I have is the whole shebang nat'ed through to the dsl ... %in the dmz and _have it go back out on the same interface_ -> I'm ... %to the server as coming from the nat box itself, ...
    (comp.unix.bsd.openbsd.misc)
  • Re: DSL
    ... As someone has already pointed out, you can connect to your DSL provider ... what does matter is that your interface is set up properly. ... IP that you are using c-net and your DNS should be: ... Now go back to the Connections tab & click on the Properties for eth1. ...
    (Ubuntu)
  • pf multiple networks, two gateways, route-to question
    ... Now what I have is the whole shebang nat'ed through to the dsl interface -- ... rdr critical ports from both the cable and dsl interfaces to the servers ... could do a reverse nat rule so that requests to the cable interface appear ...
    (comp.unix.bsd.openbsd.misc)