loadable kernel modules

From: giamma (gmario.tamagnone_at_libero.it)
Date: 08/03/03

  • Next message: Eric 'Nick' Nicolich: "Re: loadable kernel modules" 
    To: freebsd-newbies@freebsd.org
Date: Sun, 3 Aug 2003 02:11:33 +0200

    Hi, i'm a newbie for FreeBSD and I've just installed the 5.0 on my box. Here
    is the problem: I've an internal modem on COM3, and after running sysinstall
    I've discovered that i've only 2 serial ports (cuaa0 and cuua1) corresponding
    to COM1 and COM2. How can I do to set up a new serial port on COM3?
    I must rebuild my kernel? Or edit /etc/rc.serial? Or i have to use mknod?
    Thanks in advance for your help!!!
    Greetings, Gianmario Tamagnone.

    _______________________________________________
    freebsd-newbies@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-newbies
    To unsubscribe, send any mail to "freebsd-newbies-unsubscribe@freebsd.org"

  • Next message: Eric 'Nick' Nicolich: "Re: loadable kernel modules"

    Relevant Pages

    • Re: Serial Port hangs in release
      ... I would have thought COM1: would have been my problem as the OemDebug stuff ... I have a PXA255 platform using 3 serial ports. ... In debug mode I ... acessed by debug using address COM3:, COM3 hardware is acessed by COM2:... ...
      (microsoft.public.windowsce.platbuilder)
    • Re: Serial Port hangs in release
      ... I would have thought COM1: would have been my problem as the OemDebug stuff ... I have a PXA255 platform using 3 serial ports. ... In debug mode I ... acessed by debug using address COM3:, COM3 hardware is acessed by COM2:... ...
      (microsoft.public.windowsce.platbuilder)
    • RE: Serial Port hangs in release
      ... have no problems, however my serial ports mobe number, COM1 hardware is ... also have a modified serial driver for COM1 and COM3, ... REG_DWORD DeviceArrayIndex 2 ...
      (microsoft.public.windowsce.platbuilder)
    • Serial Port hangs in release
      ... have no problems, however my serial ports mobe number, COM1 hardware is ... My problem occurs when we go to release, when acessing COM3: ... also have a modified serial driver for COM1 and COM3, ...
      (microsoft.public.windowsce.platbuilder)
    • Re: getting in
      ... In most PCs that I have seen, COM3 is either not connected at all, ... the standard serial ports that are connected ... I have one serial port on my PC so I used the pc connector then the ...
      (comp.dcom.sys.cisco)