Re: SATA
From: Warren Block (wblock_at_wonkity.com)
Date: 05/04/04
- Previous message: Florian: "Re: SATA"
- In reply to: Florian: "SATA"
- Next in thread: Dan Strick: "Re: SATA"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 3 May 2004 20:06:34 -0600 (MDT) To: Florian <kerith@gmx.net>
On Tue, 4 May 2004, Florian wrote:
> On advice, I downloaded FreeBSD 4.10 RC2 (because 5.2.1 would not work)
> but can't install it because the installer does not find my HDD which is a
> 120gb Seagate drive on an on-board Silicon Image SiI 3112 SATARaid
> Controller.
> Is SATA support not yet implemented in RC2 but in the 4.9? Or is SATA only
> supported in 5.x?
> What can I do?
I just finished upgrading a system to a new motherboard with SATA. To
do that, I loaded a normal parallel IDE drive, installed to it, and then
used dump to move the install over to the SATA drive. Editing
/etc/fstab to use ad4 instead of ad0 was the next step, and then finally
setting the BIOS to boot from the SATA drive.
-Warren Block * Rapid City, South Dakota USA
_______________________________________________
freebsd-newbies@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-newbies
To unsubscribe, send any mail to "freebsd-newbies-unsubscribe@freebsd.org"
- Previous message: Florian: "Re: SATA"
- In reply to: Florian: "SATA"
- Next in thread: Dan Strick: "Re: SATA"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
