FBSD 4.8 ftp install with 3c509B: "ep0 device is not configure" ??
From: Rob Lahaye (lahaye_at_users.sourceforge.net)
Date: 06/30/03
- Previous message: bsd_at_perimeter.co.za: "Ports Name changes"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: Mon, 30 Jun 2003 17:21:17 +0900 To: freebsd-questions@freebsd.org
Hi,
I'm installing FreeBSD 4.8 from floppies and want to proceed with ftp installation.
This is on a fixed network at the university. The ethernet card is 3Com 509B (the BIOS
says it's on interrupt 5).
During the installation, after I have entered the network info, I get a message
that says "ep0 device is not configured.". It also says I should configure it later
in the Network setup (where is that Network setup??).
I have installed FreeBSD on a PC with a realtek ethernet card, and that installs
like a charm. The realtek ethernet card is recognized without any trouble.
So what's going on here and why do I run into this trouble with the 3Com509B card?
Is "ep" device not part of the kern.flp/mfsroot.flp kernel?
Help is very much appreciated!
Thanks so much,
Rob.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
- Previous message: bsd_at_perimeter.co.za: "Ports Name changes"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
|
