installing 4.9-R: READ command timeout
From: Jon Drukman (jsd_at_cluttered.com)
Date: 11/02/03
- Previous message: Adrian Fisher: "Installation problems"
- Next in thread: Peter Rosa: "Re: installing 4.9-R: READ command timeout"
- Reply: Peter Rosa: "Re: installing 4.9-R: READ command timeout"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: freebsd-questions@freebsd.org Date: Sun, 02 Nov 2003 11:57:55 -0800
i'm trying to install 4.9-RELEASE from the bootable CDROMs. i can't get
very far because it hangs during the boot process with the following error:
ad3: READ command timeout tag=0 serv=0 resetting
ata1: resetting devices...
and that's it. total freeze.
i've done a little googling and most of the suggestions i've found
center around drive cabling/jumpering. however, the system is totally
functional under Windows XP (that's how i'm writing this message) so i'm
pretty sure all the hardware is wired up properly.
ideas?
hardware: asus a7n8x motherboard, athlon xp 2200+, onboard IDE
primary master: western digital wd1200JB
primary slave: yamaha crw-f1e cd-rw
secondary master: western digital wd1200JB
secondary slave: ibm dtla-307045
-jsd-
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
- Previous message: Adrian Fisher: "Installation problems"
- Next in thread: Peter Rosa: "Re: installing 4.9-R: READ command timeout"
- Reply: Peter Rosa: "Re: installing 4.9-R: READ command timeout"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|