Re: Serial Device Views
From: Warren Block (wblock_at_wonkity.com)
Date: 05/30/04
- Previous message: adp: "Can I specify the resolver timeout?"
- In reply to: Grant Peel: "Serial Device Views"
- Next in thread: Murray Taylor: "Re: Serial Device Views"
- Reply: Murray Taylor: "Re: Serial Device Views"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sun, 30 May 2004 11:15:13 -0600 (MDT) To: Grant Peel <gpeel@thenetnow.com>
On Sun, 30 May 2004, Grant Peel wrote:
> I have a switch (managed), that I can use HyperTerminal (when connected to a
> windows box of course) to view the console.
>
> I seem to be going blind reading the docs on how to view the same console
> when I connect the Switch to the Serial (RS-232 port on any of my FreeBSD
> servers.
>
> Any hints, comments on how to set up freebsd to allow access to the switch
> console would be appreciated.
cu -s9600 -l/dev/cuaa0
Change the values if needed. And the next question is "How do I get out
of it?" which is the key sequence "~." (tilde-dot).
-Warren Block * Rapid City, South Dakota USA
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
- Previous message: adp: "Can I specify the resolver timeout?"
- In reply to: Grant Peel: "Serial Device Views"
- Next in thread: Murray Taylor: "Re: Serial Device Views"
- Reply: Murray Taylor: "Re: Serial Device Views"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|