Re: 3Com Etherlink III ISA support [was Question]
From: stheg olloydson (stheg_olloydson_at_yahoo.com)
Date: 08/31/04
- Previous message: Konrad Heuer: "Re: LDAP, pam, nss"
- Next in thread: Olaf Hoyer: "Re: 3Com Etherlink III ISA support [was Question]"
- Reply: Olaf Hoyer: "Re: 3Com Etherlink III ISA support [was Question]"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 30 Aug 2004 22:25:09 -0700 (PDT) To: altonwong78@hotmail.com
it was said:
by: A W
>Sorry im a total Newb to this Freebsd thingy. But if i were to do wat
>u told me to do and get Version 2.2.2 of FreeBsd, Which files do i
>need to start the installation?
by: stheg olloydson
>>I used that card in 2.2.2. (My first FBSD install!) As I remember, I
>>had to run a 3Com DOS utility to set the physical parameters
>>manually. Then I configured FreeBSD to use those settings.
>>I would think later versions would support that card, as well. You
>>probably just need to do what I did. If you don't have the 3Com
>>disk, you can download what you need from their site.
Hello,
Please keep the list in the loop.
Hold on there! I didn't say to run 2.2.2. It was nice back in the day,
but if you were to run it now, the Huns would sack your village. What I
meant to communicate is you should use the 3Com software to configure
the NIC manually and then enter that configuration - if needed - when
setting up your interface.
HTH (by being more clear),
Stheg
P.S. Another poster asked why do you think your NIC doesn't work. That
is a good question. What output do you get from ifconfig -a ?
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
- Previous message: Konrad Heuer: "Re: LDAP, pam, nss"
- Next in thread: Olaf Hoyer: "Re: 3Com Etherlink III ISA support [was Question]"
- Reply: Olaf Hoyer: "Re: 3Com Etherlink III ISA support [was Question]"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
