Unable to install
From: Kenneth Shipman (shipmank_at_hotmail.com)
Date: 02/18/05
- Previous message: Frank Laszlo: "Re: need help with script and sed"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: freebsd-questions@freebsd.org Date: Fri, 18 Feb 2005 10:49:11 -0800
I can maker it to 'fraustrated', but not quite to Newbie.
I'm a long time Windows developer & thought that I'd put FreeBSD on one of
my systems & play with it to see if I liked it. If I did, turn it into a new
file server.
I can't even get the install disks to boot. I guess what I'm asking for is
HELP before I get too frustrated & throw the towel in on BSD.
When I use floppies it errors out with an elf32 read error on KERN1 disk.
I've formatted & tried multiple floppies to make sure it wasn't the floppy
itself. I was able to make it as far as sysinstall about a week ago on the
same machine. but I stopped to finish building it. At that time I had a
single 450 CPU & no other OS. I've also put in a new floppy drive since
then.
When I try the ISO CD install it isn't recognised on my SCSI drive, but
starts for a few seconds on the CDROM in Master position on my 2nd IDE
channel. It prints out about two lines (goes by super quick) that says
something to the effect that 'loader found'. The same CD will boot up into
sysinstall on a different machine without problems.
Note that I do change my BIOS boot sequence as needed. I've already
installed MSDOS 6.2 & Windows 2000 Pro. That went perfect without a hitch.
PnP OS & ACPI are turned off in the BIOS.
Here's the system:
Soyo SY-D6IBA motherboard with Dual Pentium III 550s (could dual CPUs be the
problem?)
Award Modular PCI/PNP 686 BIOS 4.51 w/ PnP 1.0A extension
512mb ram
AGP slot: NVidea TNT Model 64 v2.05.13
PCI 1: Linksys LNE100TX NIC
PCI 4: Promise SX4000 Raid Controller with 4 Maxtor 300gb Diamondmax 10
drives. Two of which are in a raid 1 configuration with an NTFS partition.
The other 2 empty/unallocated. 256 mb ram.
ISA : SoundBlaster AWE64 Gold
balance of slots are empty.
New Samsung 3.5" floppy
IDE Channel 1 Master: Western Digital WD Caviar 13.6GB HDD which has both
my MSDOS & W2K OS partitions.
IDE Channel 1 Slave: Maxtor DiamondMax 10 300GB PATA 133 HDD - 1 partition -
planned location for FreeBSD 5.3
IDE Channel 2 Master: Phillips CDD3610/81 CD-ROM CD-R/RW. This is the one
used when the installer reboots in an infinite loop.
IDE Channel 2 Slave: Western Digital WD Caviar 80GB HDD - unallocated yet
Any help would be greatly appreciated.
Sincerely,
Ken Shipman
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"
- Previous message: Frank Laszlo: "Re: need help with script and sed"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
