NanoBSD don't boot.
- From: Peter Ankerstål <peter@xxxxxxxx>
- Date: Tue, 21 Feb 2006 17:04:24 +0100
I've found a pdf about installing NanoBSD on phk.freebsd.dk. Everything worked out quite well. Untill I tried to boot the CF card (I've had no problem booting a standard minimal install from the CF before.) This is what I did:
* sh nanobsd.sh -c uchman.conf ( http://pean.org/uchman.conf )
* dd if=_.disk.full of=/dev/ad4 bs=64kb (ad4 == my CF-card)
Everything seems to work fine but when I try to boot it just says:
\ (looks like it tries to load the kernel)
BTX loader 1.00 BTX version is 1.01
and then nothing.
I tried to boot the machine with a freebsd-installation and set the partitions bootable but
no success. What could have gone wrong?
_______________________________________________
freebsd-questions@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@xxxxxxxxxxx"
- Prev by Date: re: PPPoE Max Tunnels,
- Next by Date: Re: Making APC 500 Back UPS (basic) work with FreeBSD
- Previous by thread: re: PPPoE Max Tunnels,
- Next by thread: getting started with USB hard drive
- Index(es):
Relevant Pages
|
|
