Re: MTU question

Modulok wrote:
On 6/30/07, chloe K <chloekcy2000@xxxxxxxx> wrote:
Hi all

ls our network provider insists to set the mtu to 1600? but I can only set
the freebsd as 1500.

ls there any network issue?

thank you

A value of 1600 is not standard compliant. A value of 1500 is the
largest MTU for standard ethernet, as stated in RFC 894 - "A Standard
for the Transmission of IP Datagrams over Ethernet Networks", and RFC
1191 - "Path MTU discovery." Perhaps your provider is confused?

RFC 894:
"...the maximum length of an IP datagram sent over an Ethernet is 1500 octets."

That's correct, but...

perhaps they're not using Ethernet? Some layer 2 technologies also
support larger frames, e.g. 4k. However, any router can (and generally
will) fragment an IP packet into many IP packets so that they fit into
smaller MTUs (provided the don't fragment bit is not set). Those packets
will then be routed independently of each other, and usually reassembled
at the end point by the TCP stack of the receiving machine.

As far as overriding this to a higher value, you may be restricted in
doing so by your hardware, as stated in the ifconfig(8) manpage,
"...Not all interfaces support setting the MTU, and some interfaces
have range restrictions."

-Modulok-

There are also some other reasons to avoid jumbograms and stick
to Ethernet's 1500 MTU (or less, as specified by the ISP, often if they
tunnel their traffic to their upstream provider).

-cpghost.

--
Cordula's Web. http://www.cordula.ws/

_______________________________________________
freebsd-questions@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • RE: TCP/IP Stack Hardening
    ... When PMTU is disabled, the default MTU is 1500 for local subnet and 576 for ... disabling PMTU is probably not the most important network stack ... I've not found disabling ICMP redirects a problem as long as the routing ...
    (Focus-Microsoft)
  • Re: troubles with outgoing tcp/ip after sp1
    ... I recently had the same trouble on our network and came within a week ... Whenever I would hack registries and lower my MTU, ... Database replications and DTS packages failing, ... responsible for what you do, blah blah blah, cover my butt, etc. ...
    (microsoft.public.windows.server.networking)
  • Re: Browser hangs Web site cannnot be displayed
    ... >All anti-virus software was uninstalled with the system restore. ... >windows firewall on or off does not make a difference. ... >MTU settings to 1500 and various increments below that but that didn't help. ... # Another computer, on this same network, works fine. ...
    (microsoft.public.windowsxp.network_web)
  • Re: Remote HMC Access setup
    ... Subject: Remote HMC Access setup ... to allow the MTU size. ... While our network colleagues are investigating the ... For IBM-MAIN subscribe / signoff / archive access instructions, ...
    (bit.listserv.ibm-main)
  • Re: set maximum ip-packet-size ?
    ... If it is an ethernet interface (like eth0, connected to a router or gateway), ... the default MTU will most likely have the default ... You can use the ifconfig command to alter this setting ... (for any network interface). ...
    (comp.os.linux.networking)