Re: Panic on boot
- From: Derek Ragona <derek@xxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Sun, 16 Dec 2007 09:58:38 -0600
At 07:32 PM 12/15/2007, jekillen wrote:
On Dec 15, 2007, at 5:21 PM, jekillen wrote:
Hello;
I have had an AMD64 754 system that I have 64 bit SCSI card and
two 15k rpm SCSI drives. It has been running fine with FreeBSD v 6.0
for about two years now. I have several things I wanted to change
and reconfigure, software wise, and hardware wise. The first was a new
case which I got today. I shut down the system, put everything in the new
case and booted. It booted without any complaint. I got the V6.2 install
cd and put it in. The system froze during boot process after an entry
for mpt 0. I turned off the power and tried rebooting into the install cd.
This time it made it to sysinstall and went through slice and partitioning
and was in the process of installing the base system and it froze again,
no error messaged to console. I rebooted and started again. The second
time I got all the way through the install process.
Now on reboot the system is panicking just after the line
mtp0 hidden device members(6)
The error is:
Fatal Trap 12 (the screen does not persist
long enough to transcribe it all.)
Three tries, the same thing in the same place in the boot
process.
I tried it agian and the same thing happened.
This time I got more of the error message.
'page fault while in kernel mode'
does this mean the scsi drives or card is going bad? (I nope not)
the card is LSI Logic 64 bit card (installed in a standard PCI slot but
has been working with an inch of the card hanging off the end
of the slot. I only have one internal bus available this way, but that is
all I need.
Thanks in advance for info
Jeff K
(chewing my fingernails)
Jeff,
Could be anything causing this from your "move" such as damaged ram or other component from static or a somewhat flaky power supply in the new case.
Have you run diagnostics on the hard drives?
Make sure all your power connectors are tight, no damaged cables. It is easy with some SCSI cables to damage the cable or connectors, I know I have done that a few times.
If you can, separate the power to the hard drives to separate lines from the power supply rather than daisy chaining a power line with multiple connectors on it.
Have you tried other bootable OS's just to see if they crash too?
-Derek
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
_______________________________________________
freebsd-questions@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@xxxxxxxxxxx"
- Follow-Ups:
- Re: Panic on boot
- From: jekillen
- Re: Panic on boot
- References:
- Panic on boot
- From: jekillen
- Re: Panic on boot
- From: jekillen
- Panic on boot
- Prev by Date: Re: Lost FreeBSD slices (labels?) after NetBSD install -- please help!!
- Next by Date: Re: (postfix) SPAM filter?
- Previous by thread: Re: Panic on boot
- Next by thread: Re: Panic on boot
- Index(es):
Relevant Pages
|
