Re: panic: free: guard1 fail @ 0x6c23c
- From: Erik Trulsson <ertr1013@xxxxxxxxxxxxx>
- Date: Thu, 28 Feb 2008 16:35:57 +0100
On Thu, Feb 28, 2008 at 03:16:35PM +0000, Pedro Almeida wrote:
I upgraded my system from 6.2 to 7.0 using cvsup.
I'm using ULE and device polling. After doing make installworld and reboot,
the system
don't boot anymore. I have some variables in make.conf, but I don't know if
this the cause of the problem.
CPUTYPE?=p3
CFLAGS= -O2 -pipe -funroll-loops -ffast-math
COPTFLAGS= -O2 -pipe -funroll-loops -ffast-math
Any ideas of how to fix this? Thanks a lot
I don't know if the make.conf variables you show are the cause, but it would
not surprise me. I would suggest you remove CFLAGS and COPTFLAGS entirely from
make.conf and just relying on the default values for them (which are
'-O2 -pipe -fno-strict-aliasing'.
The flags you use are unlikely to bring any noticable improvements compared
to the default, but are likely to make code misbehave.
Can't work out which disk we are booting from.
Guessed BIOS device 0xffffffff not found by probes, defaulting to disk0:
panic: free: guard1 fail @ 0x6c23c
from /usr/src/sys/boot/i386/loader/../../common/module.c:959
press any key to reboot
--
<Insert your favourite quote here.>
Erik Trulsson
ertr1013@xxxxxxxxxxxxx
_______________________________________________
freebsd-questions@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@xxxxxxxxxxx"
- References:
- panic: free: guard1 fail @ 0x6c23c
- From: Pedro Almeida
- panic: free: guard1 fail @ 0x6c23c
- Prev by Date: Re: Using ZFS on FreeBSD 7.0
- Next by Date: RE: Inet access via serial interface
- Previous by thread: Re: panic: free: guard1 fail @ 0x6c23c
- Index(es):
Relevant Pages
|
|
