Re: bad performance on ATA promise controllers
From: José M. Fandiño (freebsd_at_fadesa.es)
Date: 05/28/03
- Previous message: Eriq Lamar: "nic rtl8201 phy support in freebsd"
- Maybe in reply to: José M. Fandiño: "bad performance on ATA promise controllers"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: Wed, 28 May 2003 12:57:52 +0200 To: stable@freebsd.org
"Jim" wrote:
> I've had uglyness between the earlier via chipsets and the promise ata-100 set (data corruption of large files during dma mode transfers). Your problem almost seems like the promise adapter is falling back to one of the PIO modes under freebsd.
Hello Jim,
CPU was 90% idle during tests, so I suppose
that disks weren't in PIO mode.
regards,
> -----Original Message-----
> From: José M. Fandiño [mailto:freebsd@fadesa.es]
> Sent: Monday, May 26, 2003 10:14 AM
> To: stable@freebsd.org
> Subject: bad performance on ATA promise controllers
>
> Hello friends,
>
> I'm having a problem with my home server (ASUS A7V133 motherboard) which has
> a horrible performance with ATA disks connected to an integrated promise
> controller.
>
> Below you can see iozone results of the same disk connected to the primary/
> secondary controller versus the promise one.
>
> Promise ATA100 controller:
> =========================
> Version 1.02a ------Sequential Output------ --Sequential Input- --Random-
> -Per Chr- --Block-- -Rewrite- -Per Chr- --Block-- --Seeks--
> Machine Size K/sec %CP K/sec %CP K/sec %CP K/sec %CP K/sec %CP /sec %CP
> damocles 1G 7285 18 7235 3 5198 3 18830 58 19332 7 180.5 0
>
> VIA 82C686 ATA100 controller:
> ============================
> Version 1.02a ------Sequential Output------ --Sequential Input- --Random-
> -Per Chr- --Block-- -Rewrite- -Per Chr- --Block-- --Seeks--
> Machine Size K/sec %CP K/sec %CP K/sec %CP K/sec %CP K/sec %CP /sec %CP
> damocles 1G 24301 63 25047 11 13182 8 29843 85 30678 12 185.1 1
>
> There is a big diference, 7MB/s connected in the promise and 24MB/s in the 686
> and using UltraDMA-100 in both cases.
> Transfers between ATA devices are even worse, certain combinations give me
> transfer rates as low as 1MB/s :-?
> I tried with other disks/ata cables and the results where identical.
>
> If I boot GNU/Linux in the same machine all disks work as expected in
> the promise controller, so this make me think that it's a specific problem
> with FreeBSD.
>
> Until now, I haven't had any luck searching in the mailing list archives
> about this problem so I'm trying to asking here. Does anyone know where the
> problem could be?
>
> Thanks
>
> ** dmesg:
> http://www.fadesa.es/misc/promise.txt
-- -----BEGIN GEEK CODE BLOCK----- Version: 3.1 GCS/IT d- s+:+() a- C+++ UBL+++$ P+ L+++ E--- W++ N+ o++ K- w--- O+ M+ V- PS+ PE+ Y++ PGP+>+++ t+ 5 X+$ R- tv-- b+++ DI D++>+++ G++ e- h+(++) !r !z ------END GEEK CODE BLOCK------ _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"
- Previous message: Eriq Lamar: "nic rtl8201 phy support in freebsd"
- Maybe in reply to: José M. Fandiño: "bad performance on ATA promise controllers"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
