Re: DELL PowerEdge 2850 and FreeBSD 5.4

From: Claus Guttesen (kometen_at_gmail.com)
Date: 05/31/05

  • Next message: Brent Casavant: "Re: libpthread problem (segfaults)" 
    Date: Tue, 31 May 2005 17:15:29 +0200
To: Danny Cooper <danny.cooper@uk.tiscali.com>

    > I have installed FreeBSD 5.4 RELEASE and upgraded to -STABLE on a DELL
    > PE2850.
    >
    > FreeBSD 5.4-STABLE #1: Wed May 25 23:43:12 BST 2005
    > CPU: Intel(R) Xeon(TM) CPU 3.20GHz (3192.22-MHz 686-class CPU)
    > real memory = 5100273664 (4864 MB)
    > avail memory = 4189892608 (3995 MB)
    > MPTable: <DELL PE 016D >
    > FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
    > cpu0 (BSP): APIC ID: 0
    > cpu1 (AP): APIC ID: 6
    > amr0: <LSILogic PERC 4e/Di> Firmware 516A, BIOS H418, 256MB RAM
    >
    > I have disabled ACPI HTT and enabled PAE to make the whole system memory
    > available.
    >
    > However the problem I have is the system can crash at any moment, and is not
    > load related. As the crash info below is when the machine was in an 100%
    > idle state.

    I have the same hardware as well, running on the i386-port. I have
    disabled usb with usbd_enable="NO" in /etc/rc.conf. I have no idea
    whether this helps but havent't had an issue with the 2850. Except
    with a qlogic-hba and the isp-driver (I suspect) *on* amd64, but *not*
    on i386.

    Claus
    _______________________________________________
    freebsd-stable@freebsd.org mailing list
    http://lists.freebsd.org/mailman/listinfo/freebsd-stable
    To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"

  • Next message: Brent Casavant: "Re: libpthread problem (segfaults)"