device em0 not showing up at boot
From: Forrest Aldrich (forrie_at_forrie.com)
Date: 11/29/05
- Previous message: Kris Kennaway: "Re: Reduced java/tomcat performance 6-beta3 -> 6-stable ?"
- Next in thread: Lowell Gilbert: "Re: device em0 not showing up at boot"
- Reply: Lowell Gilbert: "Re: device em0 not showing up at boot"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Mon, 28 Nov 2005 19:17:24 -0500 To: freebsd-stable@freebsd.org
I have an older PC (Compaq AP200) that I'm running FreeBSD-6.0 on.
I have an Intel Gigabit interface installed in one of the PCI slots,
along with another dual 10/100 Intel in another.
The "em0" device does not show up at boot time, and therefore the
firewall rules fail.
However, if I go in and manually type "ifconfig em0" it then becomes
available and I'm able to run dhclient on it, etc. etc.
I just did a buildworld/installworld today, so the OS is fairly current.
In /etc/rc.conf I have a simple ifconfig_em0="DHCP".
I wonder if this is a known problem...
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"
- Previous message: Kris Kennaway: "Re: Reduced java/tomcat performance 6-beta3 -> 6-stable ?"
- Next in thread: Lowell Gilbert: "Re: device em0 not showing up at boot"
- Reply: Lowell Gilbert: "Re: device em0 not showing up at boot"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
