Re: sio driver sucks

O. Hartmann wrote:
Had those overflows many times when I used FreeBSD 6.0-STABLE,
6.1-STABLE and a modem.
But this never had a so bad influence forcing me into using uart.

I tried to configure cisco router plugged in a serial port. It was very
uncomfortable. It hangs for a few tens seconds after every a few minutes.

--
Dixi.
Sem.
_______________________________________________
freebsd-stable@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@xxxxxxxxxxx"

Relevant Pages

  • Re: winmodem on ubuntu, nearly done
    ... modulation-demodulation (hence the term modem) data compression using the ... hardware (UART chip) on the modem ... modulation-demodulation or with data compression. ...
    (alt.os.linux)
  • Re: Why is sio.c still broken?
    ... On Mon, 29 Jun 2009, Kevin Oberman wrote: ... I was about to trash a modem because the HDLC and buffer overflows were ... It's probably best to convert to use of uart which is the new serial ... Since it seems to work now, perhaps I better stop upgrading. ...
    (freebsd-stable)
  • Re: speeds for pppd
    ... >> that only gave a list of chips ... You have the UART eg: ... I'll have a broadband connection in the next week or so. ... right cable to connect the modem to the PC. ...
    (comp.sys.sun.admin)
  • Re: pppd hangs: problem found and solved (almost)
    ... >> not a Hayes command or switch setting.) ... >AT which precedes all modem commands. ... >that setting in the Line Control Register of the serial device's UART. ... serial port between the computer and the modem. ...
    (comp.os.linux.networking)
  • Re: Still trying to dial-in
    ... that the CPU is not directly involved. ... is a self-contained external modem. ... a UART - which converts that serial data into buffered parallel data. ... No - the Baud rate is limited by the audio capability of the phone wire ...
    (comp.dcom.modems)