Re: hp c class blade
- From: Oliver Fromme <olli@xxxxxxxxxxxxxxxxx>
- Date: Fri, 17 Nov 2006 17:51:49 +0100 (CET)
Claus Guttesen wrote:
I've installed FreeBSD 6.2 RC1 onto a BL460c blade. The installation
itself went fine, but there is no network. The nic is on a broadcom 16
ports GB switch on the backside of the blade-chassis.
I have booted in safe mode and without acpi, but still no nic unfortunately.
What kind of NIC is it? Type "pcicinf -lv" and look for it.
If you tell us the name, vendor ID and device ID (or even
better, the whole section from pciconf output), someone
might be able to tell you details about the support status
of it in FreeBSD.
Best regards
Oliver
--
Oliver Fromme, secnetix GmbH & Co. KG, Marktplatz 29, 85567 Grafing
Dienstleistungen mit Schwerpunkt FreeBSD: http://www.secnetix.de/bsd
Any opinions expressed in this message may be personal to the author
and may not necessarily reflect the opinions of secnetix in any way.
"UNIX was not designed to stop you from doing stupid things,
because that would also stop you from doing clever things."
-- Doug Gwyn
_______________________________________________
freebsd-stable@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@xxxxxxxxxxx"
- Follow-Ups:
- Re: Re: hp c class blade
- From: Claus Guttesen
- Re: Re: hp c class blade
- References:
- hp c class blade
- From: Claus Guttesen
- hp c class blade
- Prev by Date: Re: Re: hp c class blade
- Next by Date: Re: kernel crash ...
- Previous by thread: Re: Re: hp c class blade
- Next by thread: Re: Re: hp c class blade
- Index(es):
Relevant Pages
|
|
