mezzanine-card in hp blade bl460c
- From: "Claus Guttesen" <kometen@xxxxxxxxx>
- Date: Mon, 27 Nov 2006 16:11:25 +0100
Hi.
I have installed a gb-mezzanine-card in my bl460c and the card is
recognized (correctly) as a bge-interface.
When I configure it with a valid ip-address status remain "no
carrier". I have put the cable in two different switches, one managed
and one un-managed. The switches do see the link as gbit, but link
remains down.
pciconf -vl | grep -A 3 -i "^bge"
bge0@pci17:4:0: class 0x020000 card=0x1707103c chip=0c167914e4 rev=0xa3 hdr=0x00
vendor = 'Broadcom Corporation'
class = network
subclass = ethernet
Likewise for bge1.
dmesg | grep -i "^bge"
bge0: <Broadcom unknown BCM5714, ASIC rev. 0x9003> irq 16 at device 4.0 on pci17
The mezzanine card has a 5715 chip according to the spec's.
regards
Claus
_______________________________________________
freebsd-stable@xxxxxxxxxxx mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@xxxxxxxxxxx"
- Prev by Date: Re: panic(): vinvalbuf: dirty bufs: perhaps a ffs_syncvnode bug?
- Next by Date: Re: 6.2-RC: Problem with SATA on ASUS Vintage AH-*1*
- Previous by thread: Regarding Multiple RAID controller support with FreeBSD 4.11
- Next by thread: rc doesn't see my script on boot
- Index(es):
Relevant Pages
|
|
