[HPADM] Temperature problem in SC10
From: Marcel Burggraeve (marcel_at_plusine.com)
Date: 06/19/03
- Previous message: Alek O. Komarnitsky (N-CSC): "[HPADM] Re: ANY way to do automounter failover on HP-UX ..."
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
To: <hpux-admin@dutchworks.nl> Date: Thu, 19 Jun 2003 16:41:45 +0200
We have the following problem at a customer site :
In the old situation we had a SC10 ( configured as JBOD ) with one
controller connected to one HP9000 system running fine.
Another controller has been installed, configuration has been changed to
split bus and the new controller has been connected to another HP9000.
Couple of days ago they received low temperature warnings via EMS for the
new installed controller.
The controller has been replaced but now they're receiving temperature
warnings on both controllers.
One controller claims the temperature is too low ( 11 degrees Celsius, event
305 ) the other one ( the 'old' controller ) claims questionable data (
event 306 ).
I find it hard to believe that both controllers are defective, does anyone
have a clue where to search for a solution ( patches, firmware, other STM
version ? )
TIA
Marcel Burggraeve
Plusine B.V.
--
---> Please post QUESTIONS and SUMMARIES only!! <---
To subscribe/unsubscribe to this list, contact majordomo@dutchworks.nl
Name: hpux-admin@dutchworks.nl Owner: owner-hpux-admin@dutchworks.nl
Archives: ftp.dutchworks.nl:/pub/digests/hpux-admin (FTP, browse only)
http://www.dutchworks.nl/htbin/hpsysadmin (Web, browse & search)
- Previous message: Alek O. Komarnitsky (N-CSC): "[HPADM] Re: ANY way to do automounter failover on HP-UX ..."
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
|
