[HPADM] RE: Networking problem
From: Johnson, Craig E (craig.johnson_at_siemens.com)
Date: 11/17/04
- Previous message: HAUTECOEUR Bruno: "[HPADM] AD/HP-UX problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: "'BAKHSHESH Kazem'" <BAKHSHEK@ESSILOR.fr> Date: Wed, 17 Nov 2004 08:27:35 -0800
Bookmarking. I have a simlar issue with an N4000 with multiple (seven)
LAN's with three active. The GBE interface, which is supposed to be the
primary, will fail after running a short time, and I have had to use the
100BT LAN instead. HP replaced the GBE card at one point, it ran OK for a
couple days, then quit. If I run the GBE as a non-routed secondary on an
upublished IP address, it works fine.
Craig
_____
From: hpux-admin-owner@DutchWorks.nl [mailto:hpux-admin-owner@DutchWorks.nl]
On Behalf Of BAKHSHESH Kazem
Sent: Wednesday, November 17, 2004 3:38 AM
To: 'hpux-admin@dutchworks.nl'
Subject: [HPADM] Networking problem
Hi admins,
I have recently installed 11.00. I have 3 network cards but only 2 cards are
active. This configuration
worked and was stable on 10.20.
Why the connexion by lan0 is not stable, I means that the connexion is lost
after somes minutes.
My searched was to install PHNE_26125 and PHNE_27886 which I did but the
problem present.
Thanks for your help
Cordialement(Best regards)
Kazem Bakhshesh(Administrateur Système : HP-UX)
E-Mail : bakhshek@essilor.fr <mailto:bakhshek@essilor.fr>
Tel : 01.72.94.73.09
--
---> Please post QUESTIONS and SUMMARIES only!! <---
To subscribe/unsubscribe to this list, contact majordomo@dutchworks.nl
Name: hpux-admin@dutchworks.nl Owner: owner-hpux-admin@dutchworks.nl
Archives: ftp.dutchworks.nl:/pub/digests/hpux-admin (FTP, browse only)
http://www.dutchworks.nl/htbin/hpsysadmin (Web, browse & search)
- Previous message: HAUTECOEUR Bruno: "[HPADM] AD/HP-UX problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
