[HPADM] K460 Internal Peripheral Bay



Hello:

I need to configure one of our older K460 systems as a standby unit for
one that currently runs applications which can only be run on HP-UX
10.20. The active system has (1) Cdrom (1) DDS 3 and (4) disk drives in
its internal peripheral bay. Using some of our decommissioned K460 I
have managed to find and install the same type devices into the same
slots of a new peripheral bay unit. I have checked that all power and
data connectors are attached to both the device(s) and peripheral
interconnect board. The bay has been inserted and the system powered on
and rebooted. I see the power lights flash for the cdrom, dds tape and
(4) disk units, but the system seems not to find all of the new devices
(i.e..e.cdrom and dds tape).

When I interrupt the boot and enter sea to search for a bootable device
I see the (4) disk but not the cdrom and dds tape units. I need to
install HP-UX 10.20 from the cdrom, any help is appreciated.



_________________________________________________
Richard Marshall | Senior Technical Specialist | Arbella Insurance Group


1900 Crown Colony Drive | Quincy, MA 02269 | ': 617.328.2921| 7:
617.515.2491 | *: Richard.Marshall@xxxxxxxxxxx


This email message is intended only for the addressee(s) and contains information that may be confidential.
If you are not the intended recipient please notify the sender by reply email and immediately delete this message.
Use, disclosure or reproduction of this email by anyone other than the intended recipient(s) is strictly prohibited.

GIF image



Relevant Pages

  • [HPADM] RE: K460 Internal Peripheral Bay
    ... the problem was the scsi ID on the cdrom drive. ... Once I reset it the system booted and I'm able to install from the cdrom ... K460 Internal Peripheral Bay ... (i.e..e.cdrom and dds tape). ...
    (HP-UX-Admin)
  • HP-UX "mksysb" ?
    ... booted from a Support+ CD ... although disk, CD and DDS tape were online, ... At least it should recognize the HP-UX ... hard disk, shouldn't it? ...
    (comp.sys.hp.hpux)
  • Re: updating hp-ux
    ... might be able to update from CDROM, running from a CDROM boot. ... HP-UX ...
    (comp.sys.hp.hpux)