[Q] Emulex HBA card and SUN SOlaris?

From: bbb bb (mccux1_at_hotmail.com)
Date: 07/29/03

  • Next message: jimi beyylorn: "a question?"
    To: sunmanagers@sunmanagers.org
    Date: Tue, 29 Jul 2003 12:26:34 +0000
    
    

    We have SUN Ultra SPARC workstation wirh Solaris 8 installed. We put an
    Emulex LP9802 HBA card in it.
    After software installed and reboot, the "hbaware" and "dfc" can only see
    SAN Tape library and SAN process. It can NOT find SAN disk on DELL/EMC.

    Does anyone has ideal?

    Thanks.

    _________________________________________________________________
    Protect your PC - get McAfee.com VirusScan Online
    http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
    _______________________________________________
    sunmanagers mailing list
    sunmanagers@sunmanagers.org
    http://www.sunmanagers.org/mailman/listinfo/sunmanagers


  • Next message: jimi beyylorn: "a question?"

    Relevant Pages

    • 2.6.x stability and oddity tale (Promise ATA/SATA, reiserfs/ext3, spontaneous reboots)
      ... to swap in 2 SATA drives instead of the Promise card connected ATA ... it crash and reboot again, ... 36GB SCSI drives forming a MD RAID1 locally and a SAN on the FC-AL card. ... in behavior between ext3 and reiserfs. ...
      (Linux-Kernel)
    • Re: system down - cant find luns
      ... >rebooted and the other servers connected to it are working fine. ... >One server still doesn't see the filesystem located on the SAN. ... >SCSI Device Information: ... It could also be that the reboot has found the lun but the kernel is ...
      (comp.unix.aix)
    • [HPADM] HP-UX connected to a EMC CX700 SAN
      ... Sometimes when we reboot or replace or update the firmware on a Cisco switch in our SAN fabric it causes the drive names to change in HP-UX. ... We can run ioscan and insf and powermt and get good paths to the new drives and then remove the old paths and reboot and it is ok?. ...
      (HP-UX-Admin)
    • Re: CentOS 4.4, QLogic SAN issue
      ... SAN Box switch. ... if I create the LVM partitions it all works properly until a reboot - ... in Documentation/ (any kernel source tree) which explains ... moving fast and there aren't that much people using san storage? ...
      (comp.os.linux.hardware)
    • Re: system down - cant find luns (correction)
      ... presenting the luns to the problem box and are you using SANSurfer? ... >> One server still doesn't see the filesystem located on the SAN. ... >> time I reboot. ...
      (RedHat)